Furukawa 24GMMR20 Manuel utilisateur

User Manual for

24GHz Multi Mode Radar

Model: 24GMMR20 (24GHz Pulse radar for vehicle use)

Date

:

February

22

,

20

2

1

File name:

24GMMR

20

_User Manual_rev

3

Document No.

:

RA

2

1

EX

00

5

24GHz High Resolution Multi-Mode Radar

Furukawa’s new 24-HR-MMR radar will improve safety,

comfort of passengers, and will provide pedestrian

protection function to automotive.

Product Features

・Small dimensions

・Behind bumper installation

・Low power consumption

・Multi-mode operation for plural applications

・Automotive interface with warning information and /or target lists

Operating temperature：－40℃~＋85℃

Operating voltage：+8V~+16V(typ.12V) ※Vehicular battery power

Current consumption：240mA(typ.)＠13.5V ※Depending on operating voltage.

Operating frequency ：24.15GHz

1. BSM System

The Blind Spot Monitoring(BSM) system is designed to assist the driver by monitoring the detection

areas on both sides of the vehicle to the rear.

BSM will alert the driver to possible vehicles in these areas in certain situations such as when

changing lanes on roads and freeways.

Multi-Mode operation

Regarding car information on the CAN-bus, radar can change its application mode to fit for the situation

automatically.

Application:

Blind Spot Detection

Lane Change Assist

Rear Cross Traffic Alert

2. FCTA System

The Front Cross Traffic Alert(FCTA) system is designed to assist the driver by monitoring the

detection areas on both sides of the vehicle to the front.

FCTA function is a function of performing a warning to the driver when the object approaching from

the front side satisfy the warning conditions.

Application:

Front Cross Traffic Alert

Intersection Cross Traffic Alert

Detection area

3.Sensor Components

The 24GMMR20 sensor consists of the following components:

・Housing: Plastic

・EMC Shield:

・RF and ECU board:

・Radome: Plastic

Figure 1: 24GMMR20 Components

FCC ID：2AHE9-24GMMR20

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference

received, including

interference that may cause undesired operation.

FCC CAUTION

Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s

authority to operate the equipment.

RSS-Gen Sec 8.4 User manual notice

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and

Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two

conditons:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of

the device.

L’éme4eur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR

d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de

licence. L’exploitation est autorisée aux deux conditions suivantes :

1) L’appareil ne doit pas produire de brouillage;

2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en

compromettre le fonctionnement.

Furukawa 24GMMR20 Manuel utilisateur

Furukawa 24GMMR20 Manuel utilisateur

dans d''autres langues

Autres documents