Identiv uTrust 5501 F Manuel utilisateur

Taper
Manuel utilisateur
uTrust 5501 F – User Manual
Version: 1.3 Page 1 of 5
User Manual
for
uTrust 5501 F HF + LF
uTrust 5501 F HF + LF DTC
uTrust 5501 F HF
Version 1.3
Author Identiv
Version 1.3
Date 14-DEC-2020
uTrust 5501 F – User Manual
Version: 1.3 Page 2 of 5
Document History
Version
Date Description of Change Author
1.0 26-OCT-2020 Initial version Identiv
1.1 29-OCT-2020 Added host pinout, mating connector information
Clarified test procedure applicability
1.2 10-NOV-2020 Updated FCC statements
1.3 14-DEC-2020 Included ISED statement in French
uTrust 5501 F – User Manual
Version: 1.3 Page 3 of 5
Table of Contents
1 Scope of the document ....................................................................................................... 4
2 Identiv uTrust 5501 F reader family .................................................................................... 4
3 Driver Installation in Windows ............................................................................................. 4
4 Host Communication Interface ............................................................................................ 4
5 Communication with Card ................................................................................................... 4
6 FCC Statements .................................................................................................................. 5
7 ISED Statement................................................................................................................... 5
uTrust 5501 F – User Manual
Version: 1.3 Page 4 of 5
1 Scope of the document
The user manual specifies the basic application of the reader by the customer.
2 Identiv uTrust 5501 F reader family
Identiv uTrust 5501 F is a family of USB based contactless card reader. The readers connect
to a host PC via USB 2.0 Full speed interface. They support ISO14443 and ISO15693 cards
in HF mode and 125 KHz LF cards. The information in this manual applies to the devices
model numbers listed below along with their respective part number, FCC ID and ISED ID:
Part Number
Product Name
FCC ID
ISED ID
905567 uTrust 5501 F HF + LF MBPUT5501F-01 7485A-5501F01
905567-2 uTrust 5501 F HF + LF DTC MBPUT5501F-01 7485A-5501F01
905567-3 uTrust 5501 F HF MBPUT5501F-01HF 7485A-5501F01HF
3 Driver Installation in Windows
Follow the sequence of steps to install the driver
Plug in the reader to a Windows PC
The PC prompts for a driver
Select Microsoft CCID driver and install the driver
The device enumerates with Identiv VID and PID strings
4 Host Communication Interface
Host communication is through the 1x5 header marked USB host.
Pinouts for USB host connector is as below:
PIN # Signal
1 Vbus
2 D-
3 D+
GND
5 Shield
The mating connector/receptacle for the header is TE Connectivity 440129-5
5 Communication with Card
Follow the procedure described below if module is tested in standalone mode when it is not
integrated into any device.
Follow the sequence of steps to communicate with the SAM card,
Plug in the reader to a Windows PC and load the driver
Launch the PCSCDIAG Utility
Insert the contact card into the card slot of the reader
Check the ATR of the card being displayed in the PCSCDIAG Utility
uTrust 5501 F – User Manual
Version: 1.3 Page 5 of 5
Follow the sequence of steps to communicate with the contactless card,
Plug in the reader to a Windows PC and load the driver
Launch the PCSCDIAG utility
Place a contactless card on top of the reader
Check the ATR of the card being displayed in the PCSCDIAG Utility.
To test the module after integration into device, follow the procedure from device
manufacturer.
6 FCC Statements
FCC PART 15.105 STATEMENT: NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC PART 15.19 STATEMENT: This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
FCC PART 15.21 STATEMENT: NOTE: The grantee is not responsible for any changes or modifications
not expressly approved by the party responsible for compliance. Such modifications could void the
user’s authority to operate the equipment.
7 ISED Statement
The device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s license-exempt RSS(s).Operation is subject to the following
two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement économique Canada applicables aux appareilsradio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
estsusceptible d'en compromettre le fonctionnement.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Identiv uTrust 5501 F Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues