uTrust 5501 F – User Manual

Version: 1.3 Page 1 of 5

uTrust 5501 F HF

Version 1.3

Author Identiv

Version 1.3

Date 14-DEC-2020

uTrust 5501 F – User Manual

Version: 1.3 Page 2 of 5

Document History

uTrust 5501 F – User Manual

Version: 1.3 Page 3 of 5

Table of Contents

1 Scope of the document ....................................................................................................... 4

2 Identiv uTrust 5501 F reader family .................................................................................... 4

3 Driver Installation in Windows ............................................................................................. 4

4 Host Communication Interface ............................................................................................ 4

5 Communication with Card ................................................................................................... 4

6 FCC Statements .................................................................................................................. 5

uTrust 5501 F – User Manual

Version: 1.3 Page 4 of 5

Identiv uTrust 5501 F is a family of USB based contactless card reader. The readers connect

to a host PC via USB 2.0 Full speed interface. They support ISO14443 and ISO15693 cards

in HF mode and 125 KHz LF cards. The information in this manual applies to the devices

model numbers listed below along with their respective part number, FCC ID and ISED ID:

905567 uTrust 5501 F HF + LF MBPUT5501F-01 7485A-5501F01

905567-2 uTrust 5501 F HF + LF DTC MBPUT5501F-01 7485A-5501F01

Host communication is through the 1x5 header marked USB host.

The mating connector/receptacle for the header is TE Connectivity 440129-5

Follow the procedure described below if module is tested in standalone mode when it is not

integrated into any device.

Follow the sequence of steps to communicate with the SAM card,

uTrust 5501 F – User Manual

Version: 1.3 Page 5 of 5

Follow the sequence of steps to communicate with the contactless card,

To test the module after integration into device, follow the procedure from device

manufacturer.

FCC PART 15.105 STATEMENT: NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation. This equipment

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

FCC PART 15.19 STATEMENT: This device complies with part 15 of the FCC rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired operation.

and Economic Development Canada’s license-exempt RSS(s).Operation is subject to the following

two conditions:

undesired operation of the device.

L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR

d'Innovation, Sciences et Développement économique Canada applicables aux appareilsradio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

(1) L' appareil ne doit pas produire de brouillage;