Porta Phone ULP16-MS Single Speaker Mode d'emploi
- Taper
- Mode d'emploi
USER MENU
Model No.: ULP16-MS(Single speaker)
1. Power ON/OFF
Power ON: Press and hold the power button till to GREEN LED blinking or light up.
Power OFF: Press and hold the power button till to the RED LED flashing.
2. Pairing(Register mode)
a). Press and hold the power button to turn headset power ON, the power LED should
blinking in Green color.
b). Enter the pairing mode: Press the volume down button at 3 times continually, then press
and hold the volume up till to the RED and Green LED blinking at alternately.
c). Main headset enter the pairing mode first then also the Remote to pairing mode.
d). The Green LED of Remote headset will several blink quickly then turn off after paired, press
the power button to quit the pairing mode, keep the Main headset on the pairing mode then can
pair with more Remote or press the power button to quit the pairing mode.
e). Repeat the above step “d” for more Remote headset paired with the same Main headset,
or press the power button to finish the pairing(register).
f). The Main headset can accept maximum 15 remotes register in full duplex, the power
LED will be flashing in ORANGE color when register remote reach 15., press power button to quit
the pairing mode)
3. Talking and listening
a). The main headset and remote headset will start to search each other after power ON, the
GREEN LED flash 1 time each 3 seconds. The headset will be link together automatically when the
pairing ID confirmed by main headset and LED turn ON in GREEN color.
b). Press the volume up and down button to adjust headset speaker sound volume.
4. CONFERENCE on MAIN
Press the switch located lower side of ear cup to make 15 headsets to separate 2 group or all in
CONFERENCE if the remote headset has registered in 2 group.
5. Mic Muted
The headset Microphone stopped automatically when the Mic boom swivel up.
FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
IC Warning:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en
The device has been tested and comply with FCC/ISEDC SAR limits.
L'Unité a été testée et répond aux limites FCC/ISEDC SAR.
To prevent possible hearing damage, do not listen at high volume levels for long periods
-
1
-
2
