10
Functions
NOTE
This toaster is electronically controlled and
will not operate until the toaster is plugged
into a 110 or 120V power outlet. Before
first use, remove any packaging material or
promotional labels attached to your toaster.
1. Insert the power plug into a 110 or 120V
power outlet. The Brownness Indicators
will illuminate from ‘0’ to ‘6’, and then align
to the selected browning setting (indicated
by the position of the Brownness Dial
and Brownness Indicators). The toaster
will revert to stand-by mode (Brownness
Indicators will dim) after a few minutes if
a button is not pressed or the dial is not
adjusted.
NOTE
When using the toaster for the first time, we
suggest toasting on the maximum setting
without bread. The toaster may emit a
thin smoke or distinct odor on initial use.
This is normal and not detrimental to the
performance of the toaster.
2. Place bread, bagels, etc into each of the
toasting slots. Ensure items for toasting are
not too large or too thick to fit in the toasting
slots.
3. Select the bread type in toasting slot using
the Bread Selection Ring.
NOTE
Various types of bread may require a
different browning setting. For example,
white light textured breads require less
toasting time, while heavier textured whole
wheat breads may require more toasting
time. Changing the Bread Selection Ring
accommodates for these changes without
changing the Brownness Selection Dial
so you always have the same browning no
matter what the bread type.
4. When using the Brownness Selection Dial,
align the needle with the desired browning
setting ‘0’ (lightest) to ‘6’ (darkest).
Indicators will illuminate and align to the
selected browning setting. The Brownness
setting is relative to each Bread Type so
there's no need to keep adjusting the setting
for different bread types if you have the
same brownness requirements.
NOTE
When toasting bread for the first time,
it is suggested to toast on browning setting
'3' (9 LED Indicators).
5. To start the toasting process, press the
lever down until it locks into place. The
Brownness Indicators will begin flashing
at “0” then start to gradually count up
indicating the level of brownness until it
reaches the selected browning setting.
6. Once the toasting cycle is complete the
carriage will move to the raised position.
Remove the toast. The brownness indicator
will re-illuminate to the previously selected
browning setting for a few minutes before
entering stand-by mode.
BTA735_USC_IB_A18.indd 10 4/12/18 1:30 pm