Yamaha Soavo-900C Le manuel du propriétaire

Soavo-900C
Yamaha
Marque
Yamaha
Modèle
Soavo-900C
Taper
Le manuel du propriétaire
1
En
English
Français
Deutsch
Español
Read this before using the speaker.
•To assure the finest performance, please read this
manual carefully. Keep it in a safe place for future
reference.
• Install the speaker in a cool, dry, clean place – away
from windows, heat sources, sources of excessive
vibration, dust, moisture and cold. Avoid sources of
humming (transformers, motors). To prevent fire or
electrical shock, do not expose the speaker to rain or
water.
•To prevent the enclosure from warping or discoloring, do
not place the speaker where it will be exposed to direct
sunlight or excessive humidity.
• Do not place the following objects on the speaker:
Glass, china, etc.
If glass etc. falls by vibrations and breaks, it may cause
personal injury.
A burning candle etc.
If the candle falls by vibrations, it may cause fire and
personal injury.
A vessel with water in it
If the vessel falls by vibrations and water spills, it may
cause damage to the speaker, and/or you may get an
electric shock.
• Do not place the speaker where foreign objects such as
water drips might fall. It might cause a fire, damage to
the speaker, and/or personal injury.
PRECAUTIONS
Soavo-900C
Speaker System
OWNER’S MANUAL
URGT
Thank you for selecting this YAMAHA Soavo-900C speaker system.
• Do not place the speaker where it is liable to be knocked
over or struck by falling objects. Stable placement will
also ensure better sound performance.
• Placing the speaker on the same shelf or rack as the
turntable can result in feedback.
• Never put a hand or a foreign object into the port located
on the rear of the speaker as this might cause personal
injury and/or damage to the speaker.
• When moving the speaker, do not hold the port as it
might cause personal injury and/or damage to the
speaker.
• Any time you note distortion, reduce the volume control
on your amplifier to a lower setting. Never allow your
amplifier to be driven into “clipping”. Otherwise the
speaker may be damaged.
• When using an amplifier with a rated output power
higher than the nominal input power of the speaker, care
should be taken never to exceed the speaker’s
maximum input.
• Do not attempt to clean the speaker with chemical
solvents as this might damage the finish. Use a clean,
dry cloth.
• Do not attempt to modify or fix the speaker. Contact
qualified YAMAHA service personnel when any service
is needed. The cabinet should never be opened for any
reasons.
• Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused
by improper placement or installation of the speaker.
01_En_Soavo-900C_URGT.p65 7/31/06, 9:11 AM1
2
En
PLACING THE SPEAKER
Place the speaker on top of the TV or inside the TV rack so
that the speaker and TV are aligned vertically.
Notes
•
Do not place the speaker on top of the TV whose area is
smaller than the bottom area of the speaker. If placed,
the speaker may fall and cause injury.
• Do not place the speaker on top of the TV with an
inclination.
• This speaker features a magnetically shielded
design, but there is still a chance that placing it too
close to a TV set might impair picture color or create
a buzzing noise. Should this happen, move the
speaker away from the TV set.
Front
Surround
Subwoofer
SUPPLIED ACCESSORIES
Fastener (4 sets)
Fastener
Soavo-900C
Peal off
the seal.
When placing the speaker on top of the TV
rack, etc.
Attach the provided fasteners at two points on the bottom
of the speaker and on top of the TV rack.
• Thoroughly wipe clean the surface where the
fastener is to be applied. Note that adhesive
strength is weakened if the surface is dirty, oily or
wet and that this may cause the center speaker to
drop.
• Do not touch the adhesive surface after peeling off
the seal as this will weaken its adhesive strength.
01_En_Soavo-900C_URGT.p65 7/31/06, 9:11 AM2
3
En
English
• Connect the screw-type terminals at the rear of the
speaker to the speaker terminals of the amplifier with the
speaker cable (sold separately).
• Connect the (+) terminals on the amplifier and the
speaker using one side of the cable. Connect the
(–) terminals on both components using the other side of
the cable.
• Connect the speaker to the center terminals of your
amplifier, making sure not to reverse the polarity (+, –). If
the speaker is connected with reversed polarity, the
sound will be unnatural and lack bass.
How to connect:
1 Loosen the knob.
2 Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
3 Insert the bare wire in to the hole.
4 Tighten the knob and secure the cable.
Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Notes
•
Do not let the bare speaker wires touch each other
as this could damage the speaker or the amplifier, or
both of them.
• Do not insert the insulation coating into the hole.
The sound may not be produced.
When using a banana plug
1 Unscrew the terminal knob.
2 Remove the cover by pulling it toward you.
3
4
Banana plug
CONNECTION TO YOUR AMPLIFIER
Before making connection, make sure that the amplifier is switched off.
–
CENTER
+
Amplifier
Soavo-900C
Tighten
Black (–)
Red (+)
Loosen
Insulation coating
Bare wire
3 Tighten the terminal knob.
4 Simply insert the banana plug into the terminal.
2
1
10 mm
(3/8")
Good No Good
01_En_Soavo-900C_URGT.p65 7/31/06, 9:11 AM3
4
En
SPECIFICATIONS
Type ............................. 2-way bass reflex speaker system
Magnetic shielding type
Driver ...................................... 13 cm (5”) cone woofer x 2
3 cm (1”) Aluminum dome tweeter
Impedance ................................................................... 6 Ω
Frequency Response ................. 56 Hz to 50 kHz (–10 dB)
to 100 kHz (–30 dB)
Nominal Input Power .................................................. 40 W
Maximum Input Power ............................................. 200 W
Sensitivity .................................................. 89 dB/2.83 V/m
Crossover Frequency ................................................ 3 kHz
Dimensions (W x H x D) ..................... 500 x 170 x 271 mm
(19-11/16” x 6-11/16” x 10-11/16”)
Weight ................................................... 8.6 kg (18.15 lbs.)
• Specifications subject to change without notice due to
product improvements.
• Care should be taken not to exceed the input power
values noted above.
ATTACHING THE FRONT COVER
The speaker and the front cover are packed separately.
To attach the front cover, line up the four salients (magnet)
on the reverse side of the front cover with the four
corresponding pegs.
Notes
• When the cover is not attached, take care not to
touch the speaker units with your hands or to exert
excessive force with tools.
• There are magnets on the reverse side of the front
cover. Do not place the front cover close to objects
that might be affected by magnets, such as TVs,
clocks, magnetic cards, diskettes etc. when you
don’t use it.
Taking care of the speaker
When you wipe this unit, do not use chemical solvents
(ex. alcohol or thinners etc.); this might damage the
finish. Use a clean, dry cloth. For heavy dirt, dampen a
soft cloth in detergent diluted with the water, wring it out,
and then clean this unit up with a soft cloth.
01_En_Soavo-900C_URGT.p65 7/31/06, 9:11 AM4
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Yamaha Soavo-900C Le manuel du propriétaire

Soavo-900C
Yamaha
Marque
Yamaha
Modèle
Soavo-900C
Taper
Le manuel du propriétaire
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes