MS908S Pro

Autel MS908S Pro Mode d'emploi

  • Bonjour! Je suis votre assistant IA et j'ai examiné le manuel d'utilisation de l'équipement de test automobile. Ce document contient des instructions de sécurité importantes et des informations sur les procédures de test appropriées. Je suis là pour répondre à vos questions concernant l'utilisation de votre appareil MaxiSys ou MaxiDAS et les précautions à prendre lors de son utilisation.
  • Que dois-je faire avant de commencer un test automobile ?
    Que dois-je faire lorsque le moteur tourne ?
    Que dois-je faire pour minimiser les risques d'accident lors de l'utilisation de l'équipement ?
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These
limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
ϋϋReorient or relocate the receiving antenna.
ϋϋIncrease the separation between the equipment and receiver.
ϋϋConnect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
ϋϋConsult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Ù
(IC only)
/