Sheet 1 of 1
Rev. C, 8-12-04
© 2003 SPX Corporation
Form No. 521078
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
Heavy-duty Truck
Wheel Step
Max. Capacity: 300 lbs.
The heavy-duty truck wheel step is designed to help the technician easily reach engine parts
.
Safety Precautions
Caution: To prevent equipment failure or damage resulting in personal injury:
•Read, understand, and follow these instructions.
- If the operator cannot read English, operating instructions and safety precautions must be
read and discussed in the operator’s native language.
- Si el operador no puede leer inglés, las instrucciones de operación y las precauciones de
seguridad deberán leerse y comentarse en el idioma nativo del operador.
- Si l’utilisateur ne peut lire l’anglais, les instructions et les consignes de sécurité doivent
lui être expliquées dans sa langue maternelle.
•Wear eye protection that meets the requirements of ANSI Z87.1 and OSHA.
•Inspect the condition of the wheel step before each use; do not use a wheel step if it’s
damaged, altered, or in poor condition.
•Do not exceed the rated capacity of the wheel step.
•The vehicle must be located on a hard, level surface to use the wheel step. The vehicle must
be stable.
•Chock the wheels of the vehicle and set the parking brake before using the wheel step.
Placement Instructions
Assembly Instructions
for: 1734
1734A
Wheel Step Placement
1. Remove pins and adjust wheel step to best fit
the width and the height of the tire; then
replace pins.
2. Carefully place wheel step over the tire.
3. Before standing on the step, test it by placing
one foot onto the grid to verify the wheel step
is secure.
Remove pins to
adjust width
Remove pins to
adjust height
-
1
dans d''autres langues
- English: OTC 1734A Operating instructions
