3 Press the power on/off and mode button to
turn on the Philips Sonicare.
4 Gently keep the bristles placed on the teeth
and in the gumline. Brush your teeth with small
back and forth motion so the bristles reach
between the teeth. Continue this motion
throughout your brushing cycle.
Note: The bristles should slightly flare. Do not
scrub.
5 To clean the inside surfaces of the front teeth,
tilt the brush handle semi-upright and make
several vertical overlapping brushing strokes on
each tooth.
Note: To make sure you brush evenly
throughout the mouth, divide your mouth into 4
sections using the Quadpacer feature (see
chapter ‘Features’).
6 Begin brushing in section 1 (outside upper
teeth) and brush for 30 seconds before you
move to section 2 (inside upper teeth). Continue
brushing in section 3 (outside lower teeth) and
brush for 30 seconds before you move to
section 4 (inside lower teeth).
7 After you have completed the brushing cycle,
you can spend additional time brushing the
chewing surfaces of your teeth and areas where
staining occurs. You can also brush your
tongue, with the toothbrush turned on or off, as
you prefer.
Your Philips Sonicare toothbrush is safe to use
on:
- Braces (brush heads wear out sooner when
used on braces)
- Dental restorations (fillings, crowns, veneers)
12
English