Furbo FURBO2.5T Dog Camera Mode d'emploi

Taper
Mode d'emploi

Ce manuel convient également à

name: Furbo Dog Camera
trademark: Furbo
model Furbo2.5T
FCC ID: 2AIBVTFFBV3
IC ID: 22715-VTFFBV3
使
使
使
-
-
FCC Compliance Statement:
Any changes or modifications not expressly approved by the party responsible for compliance could void
your authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF exposure statements
This Transmitter must not be colocated or operating in conjunction with any other antenna or transmitter.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. Ln order
to avoid the possibility of exceeding the Fcc radio frequency exposure limits, human proximity to the antenna
shall not be less than 20cm (8inches) during normal operation.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following
two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’utilisateur de lappareil doit accepter tout brouillage radioélectrique subi, meme si le brouillage est
susceptible den compromettre le fonctionnement.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.
Declaration d'exposition aux radiations:
Cet equipement respecte les limites d’exposition aux rayonnements IC definies pour unenvironnement non controle.
Cet equipement doit etre installe et mis en marche a une distance minimale de 20 cm qui separe l’element rayonnant
de votre corps.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Furbo FURBO2.5T Dog Camera Mode d'emploi

Taper
Mode d'emploi
Ce manuel convient également à

dans d''autres langues