dji MT2PD2007 Camera Drone Mode d'emploi

Marque: dji

Modèle: MT2PD2007 Camera Drone

Taper: Mode d'emploi

Camera DroneQuickStartGuide

V1.02020.07

Aircraft

DJIMini2featuresObstacleSensingandInfraredSensingSystem*,andafullystabilized3‐axis

gimbalwitha1/2.3”CMOSsensorcamerathatshoots4Kvideoand12‐megapixelphotos.

1. GimbalandCamera

2. PowerButton

3. BatteryLevelLEDs

4. DownwardVisionSystem

5. InfraredSensingSystem

6. Motors

7. Propellers

8. Antennas

9. BatteryCover

10. Charging/UpgradingPort(USB‐C)

11. microSDCardSlot

12. AircraftStatusIndicator



RemoteController

BuiltintotheremotecontrollerisDJI’slong‐rangetransmissiontechnologyOCUSYNCTM2.0,

offeringamaximumtransmissionrangeof5mi(8km)anddisplayingvideofromtheaircraftto

DJIFlyonyourmobiledeviceatupto1080p.



1. PowerButton

2. FlightModeSwitch

3. FlightPause/RTHButton

4. BatteryLevelLEDs

5. ControlSticks

6. CustomizableButton

7. Photo/VideoToggle

8. RemoteControllerCable

9. MobileDeviceHolder

10. USB‐CPort

11. ControlSticksStorageSlot

12. GimbalDial

13. Shoot/RecordButton



DownloadtheDJIFlyAppandWatchingTutorialVideos

Search“DJIFly”intheAppStoreorGooglePlayorscantheQRcodebelowtodownloadtheapp

onyourmobiledevice.



ChargingtheBatteries



CheckingtheBatteryLevelsandPoweringOn/Off



Pressoncetocheckthebatterylevel.

Press,thenpressandholdtoturnon/off.

PreparingtheAircraft

1. Removethegimbalcoverfromthecamera.



2. Unfoldthefrontarmsandthepropellers.



3. Unfoldthereararmsandthepropellers.



4. Unfolded



Unfoldthefrontarmsandthepropellersbeforetherearones.Allarmsand

propellersmustbeunfoldedbeforetakeoff.



PreparingtheRemoteController

1. Attachthecontrolsticks.



2. Pulloutthemobiledeviceholder,andthenunplugtheendwithmobilephonemarkofthe

RCcable.



3. Placethemobiledeviceontothemobiledeviceholder,andplugtheRCcableintothemobile

device.



 Ensurethecontrolsticksarefirmlymounted.

 TheremotecontrollercablewiththeLightningconnectorismountedbydefault.

Usetheappropriatecableforyourmobiledevicetoconnecttotheremote

controller.



PreparingforTakeoff

1. Powerontheremotecontroller



2. Powerontheaircraft



3. LaunchDJIFlyApp



Flight



• RemoteControllerOperation

Specifications

•Aircraft(Model:MT2PD)

Weight241g

MaxFlightTime30minutes(0windwhileflyingataconsistent15.5mph(25

kph))

OperatingTe mperatu re 32°to104°F(0°to40°C)

•Camera

Sensor1/2.3’’CMOS;Effectivepixels:12M

LensFOV:83°

35mmformatequivalent:24mm

Aperture:f/2.8

Focus:1mto∞

ISORange100‐3200

ElectronicShutterSpeed4‐1/8000s

•RemoteController

OperatingVoltage1200mA@3.7V(Android)

700mA@3.7V(iOS)

•IntelligentFlightBattery

Capacity2250mAh

BatteryTypeLiPo2S

ChargingTemperatu re41°to113°F(5°to45°C)

MaxChargingPower29W

Formoreinformation,readtheUserManual:http://www.dji.com/mini‐2

FCC Compliance Notice(For plane)

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) This device must accept any interference received, including

interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

— Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. End user must follow the specific operating

instructions for satisfying RF exposure compliance.

This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

This equipment should be installed and operated with minimum distance 20cm between

the radiator& your body.

ISED Compliance Notice

This device contains licence-exempt transmitter(s)/receiver(s) that comply with

Innovation, Science and Economic Development Canada’s licence-exempt

RSS(s). Operation is subject to the following two conditions: (1)This device

may not cause interference.(2)This device must accept any interference,

including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est

conforme aux CNR d’Innovation, Sciences et Développement économique

Canada applicables aux appareils radio exempts de licence. L’exploitation

est autorisée aux deux conditions suivantes :(1)L’appareil ne doit pas produire

de brouillage; (2)L’appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est susceptible d’en compromettre le fonctionnement.

This equipment complies with ISED radiation exposure limits set forth for

an uncontrolled environment. End user must follow the specific operating

instructions for satisfying RF exposure compliance.

This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

This equipment should be installed and operated with minimum distance 20cm between

the radiator& your body.

Cet équipement est conforme aux limites d’exposition aux rayonnements ISED

établies pour un environnement non contrôlé. L’utilisateur final doit suivre les

instructions spécifiques pour satisfaire les normes. Cet émetteur ne doit pas

être co-implanté ou fonctionner en conjonction avec toute autre antenne ou

transmetteur.

Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le

radiateur et votre corps.

dji MT2PD2007 Camera Drone Mode d'emploi

Marque: dji

Modèle: MT2PD2007 Camera Drone

Taper: Mode d'emploi

Télécharger le PDF

rapport

dans d''autres langues

English: dji MT2PD2007 Camera Drone User guide

dji MT2PD2007 Camera Drone Mode d'emploi

dji MT2PD2007 Camera Drone Mode d'emploi

dans d''autres langues

Documents connexes

Autres documents