8
Our products are designed to meet the
highest standards of quality, functionality
and design. We hope you enjoy your new
Braun product.
This appliance is designed for household
use only.
Description
1 Shaver foil
2 Cutter block
3 Foil release buttons
4 Long hair trimmer
5 On/off switch
6 Charging light
7 Low-charge light
8 Shaver power socket
9 Special cord set
10 Protection cap
Charging
Recommended ambient temperature for
charging is 41 °F to 95 °F / 5 °C to 35 °C.
The battery may not charge properly or at
all under extreme low or high temperatures.
Recommended ambient temperature for
shaving is 60 °F to 95 °F / 15 °C to 35 °C.
Do not expose the shaver to temperatures
higher than 122 °F / 50 °C for extended
periods of time.
• Using the special cord set (9), connect
the shaver to an electrical outlet with the
motor switched off and charge it for at
least one hour.
• A full charge provides up to 45 minutes
of cordless shaving time. This may vary
according to your beard growth.
Charging lights
During charging or when using the shaver,
the charging light (6) will blink green.
When fully charged, it will light up
continuously, provided the shaver is
switched on or connected to an electrical
outlet.
The red low-charge light (7) flashes when
the battery is running low. You should be
able to finish your shave.
Shaving
Press the on/off switch (5) to operate the
shaver.
Long hair trimmer
To trim sideburns, moustache or beard,
slide the long hair trimmer (4) upwards.
Tips for the perfect dry shave
For best shaving results, Braun recom-
mends you to follow 3 simple steps:
1. Always shave before washing your
face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against
the direction of your beard growth.
Cleaning
Regular cleaning ensures better shaving
performance. Rinsing the shaver head
under running water after each shave is
an easy and fast way to keep it clean:
• Press the foil release buttons (3) to lift the
shaver foil. Do not remove the shaver
foil completely.
• Switch the shaver on (cordless) and
rinse the shaver head under hot running
water until all residues have been
removed. You may use liquid soap
without abrasive substances. Rinse off
all foam and let the shaver run for a few
more seconds.
• Next, switch off the shaver and remove
the shaver foil (1). Then leave the
disassembled shaving parts to dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil onto the long hair
trimmer and shaver foil.
96664000_WaterFlex2_NA_S6-32.indd 896664000_WaterFlex2_NA_S6-32.indd 8 02.04.14 10:2802.04.14 10:28
CSS APPROVED Effective Date 10Apr2014 GMT - Printed 24Nov2015 Page 7 of 31