No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. No
patent liability is assumed with respect to the use of the information contained herein. While every precaution has been taken in the preparation of this guide, Seiko Epson Corporation assumes no responsibility for errors or omissions. Neither is any
liability assumed for damages resulting from the use of the information contained herein.
Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or
unauthorized modifications, repairs, or alterations to this product, or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation’s operating and maintenance instructions.
Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated as Original Epson Products or Epson Approved Products by Seiko Epson
Corporation.
EPSON is a registered trademark of Seiko Epson Corporation in Japan and other countries/regions.
NOTICE: The contents of this manual are subject to change without notice.
Copyright © 2013 Seiko Epson Corporation. All rights reserved.
EN Unpacking FR Déballage ES Desembalaje PT Remoção da embalagem
EN
DP-502 Installation Guide
Follow the instructions to install the optional DM-D110 on the TM-H6000IV-DT using the exclusive
DP-502 pole kit.
FR
Guide d'installation DP-502
Suivez les instructions d'installation de l'afficheur DM-D110 en option sur l'imprimante
TM-H6000IV-DT en utilisant le kit tube DP-502 exclusif.
ES
Guía de instalación de la DP-502
Siga las instrucciones para instalar la DM-D110 opcional en la TM-H6000IV-DT con el kit de tubo
exclusivo de la DP-502.
PT
Guia de instalação DP-502
Siga as instruções para instalar a DM-D110 opcional na TM-H6000IV-DT utilizando o kit de pólo
exclusivo DP-502.
EN Remove the two feet.
FR Retirez les deux pieds.
ES Extraiga las dos patas.
PT Remova as duas bases.
EN The illustration shows how to install the DM-D110 on the right side of the TM-H6000IV-DT. If
you install it on the left side, use screw hole L.
FR La figure montre comment installer l'afficheur DM-D110 à droite de l'imprimante TM-
H6000IV-DT. Si vous l'installez à gauche, utilisez un trou de vis en L.
ES La ilustración representa cómo instalar la DM-D110 en el lado derecho de la TM-H6000IV-DT.
Para instalarla en el lado izquierdo, utilice el agujero roscado L.
PT A ilustração mostra como instalar a DM-D110 no lado direito da TM-H6000IV-DT. Se instalá-la
no lado esquerdo, utilize o orifício para parafusos L.
EN Remove the connector cover. Reattach it after the DM-D110 is installed.
FR Retirez le cache-connecteurs. Fixez-le à nouveau après avoir installé l'afficheur DM-D110.
ES Extraiga la tapa de conectores. Móntela de nuevo cuando haya instalado la DM-D110.
PT Remova a tampa do conector. Recoloque-a após a DM-D110 ser instalada.
EN Use the 2 screws removed in Step 2 and the 2 included long screws.
Be sure not to connect the cables before attaching the plate. Otherwise, the cables can
be damaged.
FR Utilisez les 2 vis enlevées au point 2 et les 2 vis longues fournies avec l'appareil.
Les câbles ne doivent pas être connectés avant de fixer la plaque. Autrement, ils
risquent d’être endommagés.
ES Utilice los 2 tornillos extraídos en el paso 2 y los 2 tornillos largos suministrados.
Asegúrese de que los cables no se conecten antes de montar la placa, ya que podrían
resultar dañados.
PT Utilize os 2 parafusos removidos no Passo 2 e os 2 parafusos compridos incluídos.
Certifique-se de que não liga os cabos antes de colocar a placa. Caso contrário, os
cabos podem ser danificados.
Printed in Taiwan
412601700
EN 1. Select the position where the DM-D110 is to be installed from A, B, C, or D.
2. Move the attached part in Step 4 so that screw holes indicated in the illustration are aligned
with each other, according to the position you selected.
3. Fix it with the included screw.
NOTE:
The illustrations show how to install the DM-D110 on the right side of the TM-H6000IV-DT. If
you install it on the left side, use the screw holes at symmetric positions.
FR 1. Choisissez l'emplacement pour l'installation de l'afficheur DM-D110 entre A, B, C, ou D.
2. Déplacez la partie fixée au point 4 pour que les trous de vis indiqués par la figure soient
alignés entre eux, selon la position choisie.
3. Fixez-le avec les vis fournies.
REMARQUE:
Les figures montrent comment installer l'afficheur DM-D110 à droite de l'imprimante
TM-H6000IV-DT. Si vous l'installez à gauche, utilisez les trous de vis ayant des positions
symétriques.
ES 1. Seleccione la posición en la que debe instalarse la DM-D110 (A, B, C o D)
2. Mueva la pieza montada en el paso 4 de manera que los agujeros roscados indicados en la
ilustración queden alineados entre sí, de acuerdo con la posición seleccionada.
3. Fíjela con el tornillo suministrado.
NOTA:
Las ilustraciones representan cómo instalar la DM-D110 en el lado derecho de la TM-
H6000IV-DT. Para instalarla en el lado izquierdo, utilice los agujeros roscados en las posiciones
simétricas.
PT 1. Selecione a posição em que a DM-D110 tem de ser instalada a partir de A, B, C ou D.
2. Mova a peça colocada no Passo 4 de modo a que os orifícios do parafuso indicados na
ilustração fiquem alinhados entre si, de acordo com a posição que selecionou.
3. Fixe-a com o parafuso incluído.
Observação:
As ilustrações mostram como instalar a DM-D110 no lado direito da TM-H6000IV-DT. Se a
instalar no lado esquerdo, utilize os orifícios para parafusos em posições simétricas.
EN Use the included extension pole if the pole is not long enough.
FR Utilisez le tube de rallonge si le tube n'est pas assez long.
ES Si el tubo no es suficientemente largo, utilice el tubo alargador incluido.
PT Utilize o pólo de extensão incluído se o pólo não for suficientemente
comprido.
-
1
-
2
Epson DM-D110 Series Guide d'installation
- Taper
- Guide d'installation
- Ce manuel convient également à
dans d''autres langues
- English: Epson DM-D110 Series Installation guide
- español: Epson DM-D110 Series Guía de instalación
- português: Epson DM-D110 Series Guia de instalação