Uniden SX-167 Le manuel du propriétaire

Catégorie
Radios bidirectionnelles
Taper
Le manuel du propriétaire
F R S
2-way
radios
SX167
1
2
3
4
6
7
8
9
10
5
22 FRS Channels
Long Battery Life
Up to 16-mile Range*
Battery Strength Meter
Roger Beep
Battery Low Alert/Battery Save
Call Key
Last Channel Memory
USB Charging
NOAA Weather Radio
* Range may vary depending on environmental
and/or topographical conditions.
Congratulations on your purchase of
Uniden's SX167 series radio. This
lightweight, palm-sized radio is a
state-of-the-art device, equipped with
many valuable features. Use it at
sporting events, to stay in contact
with family and friends, hiking, skiing,
outdoors, or in a neighborhood watch
for vital communication.
PACKAGE CONTENTS
Each radio uses 3 AAA rechargeable
Ni-MH batteries, included.
If your model number contains a "C,"
your radio can be charged. A micro-
USB Y charging cable is included.
If your model number contains an
"H," your radio has a headset jack.
Headsets are not included.
Refer to the packaging for other
specific contents.
BATTERIES
Each SX167 radio comes with 3 AAA
NiMH batteries. You can also use 3
AAA Alkaline batteries (not included) .
To install the batteries (NiMH or
Alkaline):
1. If necessary, remove the belt clip.
Press up on the belt clip latch and
slide the belt clip off of the radio.
2. Remove the battery compartment
door by pressing on and sliding
out the compartment door.
Remove the cover.
3. Install the 3 AAA batteries (NiMH
included) into the battery
compartment. Be certain to follow
the + and – symbols in the
compartment. Installing the
batteries incorrectly will prevent
the unit from operating.
4. Replace the battery compartment
door by sliding the door into
place.
5. Replace the belt clip if necessary.
CHARGING THE RADIO
For models that recharge with
rechargeable NiMH batteries
installed:
1. Plug one branch of the included
microUSB Y-Cable into each
radio's microUSB charge port.
2. Insert the other end (USB) into a
USB power source (computer,
phone charger, etc - not
included).
3. The battery strength meter in the
upper right-hand corner indicates
the battery level during
recharging.
Notes:
Charge time may vary depending
on the battery life remaining. For
fastest charging, turn off the radio
before charging.
Do not try to recharge alkaline
batteries. Doing so can create a
safety hazard and/or damage the
radio.
If battery power is low, you cannot
operate the radio even using
external power. if you try to
transmit while power is low, the
radio will automatically turn off.
Recharge or replace the batteries.
USING A HEADSET
For models that have a headset jack:
You can use a headset for more
private communications. To use a
headset, lift the rubber cover from
over the headset jack, then plug in a
headset (not included).
USING THE RADIO
In order to get the most out of your
new radio, read this reference guide
completely before attempting to
operate it.
TURNING THE RADIO ON AND
ADJUSTING THE VOLUME
1. Press and hold the /CH key to
turn the radio ON. The radio
tunes to the last active channel.
2. Press and hold the /CH key to
turn the radio OFF.
Press the or keys to increase or
decrease the volume level. L1 - L8
displays as you press the keys.
CHANNEL OPERATION
Your radio has 22 channels you can
use to talk to others. In order to speak
to someone, each of you must be set
to the same channel.
CHOOSE A CHANNEL
1. With the radio on, press /CH key
once. The current channel number
flashes.
2. Use the or keys to select
other channels (1 - 22). Press and
hold or keys to rapidly
change channels.
TALK ON YOUR RADIO
To talk to others using the radio:
Once you select a channel, press PTT
to talk. When you finish talking,
release PTT. The radio sends a roger
beep at the end of your transmission
so that others know you've finished
talking.
If the other party does not hear you,
you can press CALL to send a call
alert tone.
AUTOMATIC POWER SAVE
FEATURE
Your radio has a unique circuit
designed to dramatically extend the
life of the batteries. If there are no
transmissions or incoming calls within
2 seconds, your radio switches to the
Power Save mode. The radio is still
able to receive transmissions in this
mode.
WEATHER CHANNEL
1. With the radio on, press /CH key
twice. The weather icon displays
and the radio tunes to the current
weather channel.
2. Use the or keys to select
other weather channels (1 - 10).
1 Antenna 6 Volume/Channel
Up
2 Call Key 7 USB (some
versions; see
packaging)
3 PTT (Push-to-
Talk)
8 Volume/Channel
Down
4 Power/Channel
Key
9 Microphone
5 LCD 10 Speaker
SPECIFICATIONS
Channels 22 FRS
Operating Freq. UHF 462.5500 - 467.7125 MHz
Power Source 3 AAA Rechargeable NiMH Batteries
Battery Life 20 Hours typical
(5/5/90 duty cycle)
FREQUENCY CHART
CH. FREQ
(MHz)
X-REF CH. FREQ
(MHz)
X-REF
1 462.5325 FRS/GMRS 1 12 467.6625 FRS 12
2 462.5875 FRS/GMRS 2 13 467.6875 FRS 13
3 462.6125 FRS/GMRS 3 14 467.7125 FRS 14
4 462.6375 FRS/GMRS 4 15 462.5500 GMRS 11
5 462.6625 FRS/GMRS 5 16 462.5750 GMRS 8
6 462.6875 FRS/GMRS 6 17 462.6000 GMRS 12
7 462.7125 FRS/GMRS 7 18 462.6250 GMRS 9
8 467.5625 FRS 8 19 462.6500 GMRS 13
9 467.5875 FRS 9 20 462.6750 GMRS 10
10 467.6125 FRS 10 21 462.7000 GMRS 14
11 467.6375 FRS 11 22 462.7250 GMRS 15
Note:This product is considered FRS only with 22 FRS
channels in the US market. It is considered a GMRS
product in the Canadian market.
MAINTENANCE
TO BE SAFE AND SURE:
• Never open your radio’s case.
Never change or replace anything in your radio except
the batteries.
CARE AND SAFETY
To clean the radio, use a soft cloth dampened with water.
Do not use cleaners or solvents because they can harm
the body of the unit and leak inside, causing permanent
damage. Use a dry, lint-free cloth to clean the battery
contacts. Do not submerge the unit in water. If the unit
gets wet, turn it off and remove the batteries immediately.
Dry the battery compartment with a soft cloth to minimize
potential water damage. Leave the battery compartment
cover off overnight to ensure complete drying. Do not use
the radio until the unit is completely dry.
Your radio might cause TV or radio interference even
when it is operating properly. To determine whether your
radio is causing the interference, turn it
off. If the interference goes away, your
radio is causing it. Try to eliminate the
interference by moving your radio away
from the receiver. If you cannot
eliminate the interference, the FCC
requires that you stop using the radio.
HAZARDOUS ENVIRONMENTS
Do not operate the radio in hazardous
environments. Explosion or fire may
result. Do not operate the radio near
unshielded electrical blasting caps.
Under certain conditions, radios can
interfere with blasting operations and
may cause an explosion. Turn your
radio OFF to prevent accidental
transmission when in a blasting area or
in areas posted: "Turn off two-way
radio." Construction crews often use
remote control RF devices to set off
explosives.
WARNING! Read this information
before using the radio
In August 1996 the Federal
Communications Commission (FCC) of
the United States with its action in
Report and Order FCC 96-326 adopted
an updated safety standard for human
exposure to radio frequency
electromagnetic energy emitted by FCC
regulated transmitters.
Those guidelines are consistent with
the safety standard previously set by
both U.S. and international standards
bodies. The design of the radio
complies with the FCC guidelines and
these international standards.
Never allow children to operate the
radio without adult supervision and the
knowledge of the following guidelines
RBRC INFORMATION
As part of our commitment to protect
the environment and conserve natural
resources, Uniden voluntarily
participates in an RBRC
®
industry program to collect and
recycle used Ni-MH batteries
within the US.
Please call 1-800-8-BATTERY for
Changes or modifications not expressly
approved by the party responsible for
compliance could void your authority to
operate the equipment.
Avis de conformité à la FCC : Ce dispositif
a été testé et s’avère conforme à l’article
15 des règlements de la Commission
fédérale des communications (FCC). Ce
dispositif est soumis aux conditions
suivantes: 1) Ce dispositif ne doit pas
causer d’interférences nuisibles et; 2) Il
doit pouvoir supporter les parasites qu’il
reçoit, incluant les parasites pouvant nuire
à son fonctionnement.
Tout changement ou modification non
approuvé expressément par la partie
responsable pourrait annuler le droit à
l’utilisateur de faire fonctionner cet
équipement.
IC COMPLIANCE
This device complies with Industry Canada
license-exempt RSS standard(s).
Operation is subject to the following two
conditions:
1. This device may not cause
interference, and
2. This device must accept any
interference, including interference that
may cause undesired operation of the
device.
Changes or modifications not expressly
approved by the party responsible for
compliance could void your authority to
operate the equipment.
Cet appareil est conforme aux normes
RSS exemptes de licences d’Industrie
Canada. on fonctionnement est soumis
aux deux conditions suivantes :
1. Cet appareil ne doit pas causer
d’interférences nuisibles et
2. Il doit pouvoir accepter les
interférences, incluant celles pouvant
nuire à son fonctionnement normal.
Tout changement ou modification non
approuvé expressément par la partie
responsable pourrait annuler le droit à
l’utilisateur de faire fonctionner cet
équipement.
ONE YEAR LIMITED
WARRANTY
Important: Evidence of original
purchase is required for warranty
service.
WARRANTOR: UNIDEN AMERICA
CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden
warrants, for one year, to the original
retail owner, this Uniden Product to be
free from defects in materials and
craftsmanship with only the limitations
or exclusions set out below.
WARRANTY DURATION: This
warranty to the original user shall
terminate and be of no further effect 12
months after the date of original retail
sale. The warranty is invalid if the
Product is: (A) damaged or not
maintained as reasonable or necessary,
(B) modified, altered, or used as part of
any conversion kits, sub-assemblies, or
any configurations not sold by Uniden,
(C) improperly installed, (D) serviced or
repaired by someone other than an
authorized Uniden service center for a
defect or malfunction covered by this
warranty, (E) used in any conjunction
with equipment or parts or as part of
any system not manufactured by
Uniden, or (F) installed or programmed
by anyone other than as detailed by the
owners manual for this product.
STATEMENT OF REMEDY: In the
event that the product does not conform
to this warranty at any time while this
warranty is in effect, warrantor will
either, at its option, repair or replace the
defective unit and return it to you
without charge for parts, service, or any
other cost (except shipping and
handling) incurred by warrantor or its
representatives in connection with the
performance of this warranty. Warrantor,
at its option, may replace the unit with a
new or refurbished unit.
THE LIMITED WARRANTY SET
FORTH ABOVE IS THE SOLE AND
ENTIRE WARRANTY PERTAINING TO
THE PRODUCT AND IS IN LIEU OF
AND EXCLUDES ALL OTHER
WARRANTIES OF ANY NATURE
information on Ni-MH battery recycling in
your area. (RBRC
®
is a registered
trademark of the Rechargeable Battery
Recycling Corporation.)
FCC RF EXPOSURE
WARNING! It is up to the user to
properly operate this radio transmitter to
insure safe operation. Please adhere to
the following:
Use only the supplied or an approved
antenna. Unauthorized antennas,
modifications, or attachments could impair
call quality, damage the radio, or result in
violation of FCC regulations.
Do not use the radio with a damaged
antenna. If a damaged antenna comes
into contact with the skin, a minor burn
may result. Please contact your local
dealer for a replacement antenna.
Body-Worn Operation
This device was tested for typical body-
worn operations using the supplied belt-
clip.
To maintain compliance with FCC RF
exposure requirements, body-worn
operations are restricted to the supplied
belt-clip.
For hand-held operation, the radio should
be held 1 inch from the user's face. The
use of accessories that do not satisfy
these requirements may not comply with
FCC RF exposure requirements and
should be avoided.
For more information about RF exposure,
please visit the FCC web site at www.fcc.
gov.
FCC PART 15 /
IC COMPLIANCE
FCC PART 15 COMPLIANCE
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
© 2019 Uniden America Corporation Issue 2, June 2019
All rights reserved Printed in China
WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING
BY OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO
ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE.THIS WARRANTY
DOES NOT COVER OR PROVIDE FOR THE
REIMBURSEMENT OVERPAYMENT OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES. Some states do not allow this
exclusion or limitation of incidental or consequential damages so
the above limitation or exclusion may not apply to you.
LEGAL REMEDIES: This warranty gives you specific legal
rights, and you may also have other rights which vary from state
to state. This warranty is void outside the United States of
America and Canada.
PROCEDURE FOR OBTAINING PERFORMANCE OF
WARRANTY: If, after following the instructions in the owner’s
manual you are certain that the Product is defective, pack the
Product carefully (preferably in its original packaging). The
Product should include all parts and accessories originally
packaged with the Product. Include evidence of original
purchase and a note describing the defect that has caused you
to return it.The Product should be shipped freight prepaid, by
traceable means, to warrantor:
Uniden America Service
C/O Saddle Creek
743 Henrietta Creek Rd., Suite 100
Roanoke, TX 76262
  • Page 1 1
  • Page 2 2

Uniden SX-167 Le manuel du propriétaire

Catégorie
Radios bidirectionnelles
Taper
Le manuel du propriétaire

dans d''autres langues