For more details, access to Rhombus

apps and support, and mounting

instructions, scan the QR code!

Want to learn more?

Use a PoE power source compliant with 802.3af PoE

Plug in your Rhombus Camera

Available on iOS and Android

Install the Rhombus Systems Mobile App

Follow the app’s instructions to complete registration

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Industry Canada statement:

(1) Cet appareil ne doit pas causer d'interférences

(2) Cet appareil doit accepter toute interférence, y compris les interférences pouvant provoquer un fonctionnement indésirable de l'appareil

Radiation Exposure Statement:

This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum

distance 20cm between the radiator & your body.

Déclaration d'exposition aux radiations:

Cet équipement est conforme Canada limites d'exposition aux radiations dans un environnement non contrôlé. Cet équipement doit être installé et utilisé à distance minimum

de 20cm entre le radiateur et votre corps.

EU Importer/Distributor: Schillingweg 64, 2153 PL Niew-Vennep, Amsterdam, The Netherlands

Grounding/Earthing:

• Open dome by unscrewing three housing screws with included Torx tool

• Use included mount template to drill holes for screws and cable

• Use three included M4x25mm round head self-tapping screws to mount base to surface

• Use three included anchors when mounting to softer materials

• Replace dome and tighten three housing screws with included Torx tool

Connection:

• The camera is only to be connected to PoE networks without routing to outside plants

• If powered by a power adapter, the adapter should be properly grounded

• The product will be installed under the eaves of the building and will avoid direct exposure of the external wire to the sun and water environment.

• Please contact Rhombus’ certified dealers for power adapters