Emerson Go Tracker 1.9 Manuel utilisateur

Taper
Manuel utilisateur
1
Confidential
User manual
Model Name: Go Tracker 1.9
By
Emerson Digital
Cold Chain, Inc
04/05/2022
Revision History
Revision
Date
Description
1.00
04/05/2022
Initial Release
2
CE Regulations
Caution
Risk of explosion if battery replaced aced by an incorrect type.
Dispose of used batteries according to the instructions.
The technical documentation relevant to the above equipment will be held at Emerson Digital Cold
Chain, Inc
Please make sure the temperature for the device will be from -20˚C to 60 ˚C.
The manufacturer specified the maximum ambient temperature for use in charging mode of 40 ˚C
and for use in the non-charge mode of 45 ˚C.
The minimum distance between the user and/or any bystander and the radiating structure of the
transmitter is 20cm.
This radio equipment operates with the following frequency bands and maximum radio-frequency
power
Features Description
Frequency Band
CAT M1 LTE-FDD:
B1/B2/B3/B4/B5/B8/B12/B13/B18/B19/B20/B25/B26/B27/B28/B66/B85
Cat NB2 LTE-FDD:
B1/B2/B3/B4/B5/B8/B12/B13/B18/B19/B20/B25/B28/B66/B71/B85
EGPRS: 850/900/1800/1900MHz
Max. TX power
EGPRS 900 : 33.5 dbm
EGPRS 1800 : 31 dbm
CAT M1/NB2 LTE B1/3/8/20/28: 22 dbm
3
FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiated radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could
void the user‘s authority to operate the equipment.
RF Exposure Information
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to
the antenna shall not be less than 20cm (8 inches) during normal operation.
ISED Notice
This device complies with Innovation, Science and Economic Development Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.
4
Le présent appareil est conforme aux CNR Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en
This device complies with the Canadian ICES-003 Class B specifications. CAN ICES-003(B)/ NMB-003(B)
ISED RF Exposure Statement
This device complies with ISED RSS-102 RF exposure limits set forth for an uncontrolled environment. In order to
avoid the possibility of exceeding the IC RSS-102 RF exposure limits, human proximity to the antenna shall not be
less than 20cm (8 inches) during normal operation.
Cet appareil est conforme aux limites d'exposition aux rayonnements de la CNR-102 définies pour un
environnement non contrôlé. Afin d'éviter la possibilité de dépasser les limites d'exposition aux fréquences radio
de la CNR-102, la proximité humaine à l'antenne ne doit pas être inférieure à 20 cm (8 pouces) pendant le
fonctionnement normal.
CONTACT:
Contact Person: Mona Delavari
Job Title: Certification Manager
E-mail: mona.delavari@emerson.com
Address: 7121 Fairway Dr. #400, Palm Beach Gardens, FL 33418, USA
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Emerson Go Tracker 1.9 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues