Quick Start Guide
HomeSight EM200
CANADIAN COMPLIANCE CAN ICES-003 (B)/NMB-003(B):
This device complies with Innovation, Science and Economic
Development Canada’s license-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)
L’émetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d’Innovation, Sciences
et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes :
1. l’appareil ne doit pas produire de brouillage;
2. l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est
suscepti ble d’en compromettre le fonctionnement.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE
STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, i
ncluding interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent
from that the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
FCC CAUTION: Any changes or modications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate this equipment. This
transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
RADIATION EXPOSURE STATEMENT: This equipment complies
with FCC and IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the
radiator and your body.
EU Compliance is maintained at the following address:
ARRIS Group B.V., Hoogoorddreef 5, 1101 BA Amsterdam-
Zuidoost, The Netherlands
UK Compliance is maintained at the following address:
ARRIS Global Limited, Victoria Road, Saltaire, West Yorkshire,
BD18 3LF, United Kingdom
ARRIS declares that this product is in compliance with
Directive 2014/53/EU.
The full test of the EU declaration of conformity is available at
the address: http://arris.com/consumers/eudoc.
Disabling Wireless: This equipment is dependent
on wireless for primary operation.
To disable wireless, remove the batteries from the product.
The following table shows the EU RF Output Power for CPE
wireless devices:
Frequency Band (MHz) Maximum RF Power (dBm)
2410 to 2480 20
Remote Control Batteries
CAUTION: There is Risk of explosion if the battery is replaced
by an incorrect type. Dispose used batteries according to the
instructions.
WARNING! To reduce the risk of re or burns, do not
disassemble, crush, or puncture; do not short external
contacts; do not dispose of in re or water.
© 2022 CommScope, Inc. All rights reserved.
ARRIS and the ARRIS Logo are trademarks of CommScope, Inc.
and/or its aliates. All other trademarks are
the property of their respective owners.
504-EM20000
Important safety instructions
Never place the product on top of or close to any heat sources
such as other electronic devices. Doing so will reduce product
lifetime and may cause irreparable damage or malfunction.
Do not use the product near water. Note that the ambient
temperature must be below 104° F/40° C. Be sure to maintain
necessary space around the product to allow for proper
ventilation. Never use the product outside.
1. Slide up the front cover of your EM200.
2. Use the black rubber ribbon to pull out the
batteries.
3. Replace with 2 new AA batteries and then slide
back to close the back cover
1. Drill a hole in a wall to the size of the plastic
anchor (supplied).
2. Insert the plastic anchor into the wall.
3. Secure the rear cover of your EM200 with the
M3 screw (supplied) through the hole. See the
below picture.
4. Slide the front cover in the direction shown in
the picture below.
Your HomeSight EM200 Environmental monitor
enables you to monitor real-time environmental
temperature and humidity. This device also has
the capability to monitor the light intensity, mo-
tion, and sound.
Your EM200 comes supplied with a quick start
guide, 2x AA batteries, double-sided adhesive
tape, and an M3 screw and plastic wall anchor.
Rear view
Replacing the batteries
Screw hole
Front view
Temperature/
Humidity sensor
Light sensor
Sound sensor
Bluetooth LED:
Motion sensor
Mounting your EM200
Using screw:
About Using double-sided adhesive tape:
1. Peel the outer layer of the one side of the
adhesive tape and then press your EM200
rmly to the tape.
2. Peel the outer layer of the other side of the
adhesive tape and then press the tape to
the wall.
Mounting instructions:
• Blinks Blue:
Pairing with a
supported device.
• O: EM200 is
paired successfully
with a supported
device.
NOTE: Before you power on your EM200, ensure
to pull out the battery insulation tab along the
direction specied.
Battery
insulation tab
Black rubber
ribbon
-
1
-
2
dans d''autres langues
- English: HomeSight EM200 User guide
Autres documents
-
Arris XB7 Manuel utilisateur
-
-
-
UEi Test Instruments EM200 Manuel utilisateur
-
Black & Decker EM200 Manuel utilisateur
-
Arris VIP7300 Guide d'installation
-
-
ARRIS Group ACQ-VIP5662W Manuel utilisateur
-
ARRIS Group UID2402GCT Manuel utilisateur
-
