Quick Start Guide

HomeSight EM200

CANADIAN COMPLIANCE CAN ICES-003 (B)/NMB-003(B):

This device complies with Innovation, Science and Economic

Development Canada’s license-exempt RSSs. Operation is

subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including

interference that may cause undesired operation of the device.

1. l’appareil ne doit pas produire de brouillage;

2. l’appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est

suscepti ble d’en compromettre le fonctionnement.

FEDERAL COMMUNICATION COMMISSION INTERFERENCE

STATEMENT:

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, i

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interfer-

ence will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television recep-

tion, which can be determined by turning the equipment o

and on, the user is encouraged to try to correct the

interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

RADIATION EXPOSURE STATEMENT: This equipment complies

with FCC and IC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed

and operated with minimum distance 20cm between the

radiator and your body.

EU Compliance is maintained at the following address:

ARRIS Group B.V., Hoogoorddreef 5, 1101 BA Amsterdam-

The full test of the EU declaration of conformity is available at

the address: http://arris.com/consumers/eudoc.

Disabling Wireless: This equipment is dependent

on wireless for primary operation.

To disable wireless, remove the batteries from the product.

The following table shows the EU RF Output Power for CPE

Frequency Band (MHz) Maximum RF Power (dBm)

2410 to 2480 20

contacts; do not dispose of in re or water.

© 2022 CommScope, Inc. All rights reserved.

ARRIS and the ARRIS Logo are trademarks of CommScope, Inc.

and/or its aliates. All other trademarks are

the property of their respective owners.

504-EM20000

Important safety instructions

Never place the product on top of or close to any heat sources

such as other electronic devices. Doing so will reduce product

lifetime and may cause irreparable damage or malfunction.

3. Replace with 2 new AA batteries and then slide

back to close the back cover

1. Drill a hole in a wall to the size of the plastic

anchor (supplied).

2. Insert the plastic anchor into the wall.

3. Secure the rear cover of your EM200 with the

M3 screw (supplied) through the hole. See the

below picture.

4. Slide the front cover in the direction shown in

Your EM200 comes supplied with a quick start

guide, 2x AA batteries, double-sided adhesive

tape, and an M3 screw and plastic wall anchor.

Rear view

Replacing the batteries

Front view

1. Peel the outer layer of the one side of the

adhesive tape and then press your EM200

rmly to the tape.

2. Peel the outer layer of the other side of the

adhesive tape and then press the tape to

the wall.

Mounting instructions:

direction specied.

Black rubber