Dukers DSP60-16-S2 Guide d'installation

Taper
Guide d'installation
BEFORE FIRST USE 0
It is important to perform a site survey before installing an appliance.
Remove all packaging (àDisposal instructions).
Check for completeness and transport damage. In case of damage or incomplete
delivery please contact your dealer (àGuarantee).
Clean the appliance (àCleaning).
Place the appliance on a horizontal and stable surface
Try to position the appliance close to a wall, but leave enough space for ventilation to
ensure good circulation and efficiency of the appliance.
Please keep the appliance away from substance, which can cause ignition
Do not position the appliance in direct sunlight or near any heat sources.
Protect the appliance from moisture, extreme heat or cold.
Climate class for the appliance.
Climate class and matched temperature range for reference:
Test room climate class
Dry bulb temperature
Relative humidity
°C
%
1
16
80
2
22
65
3
25
60
4
30
55
5
40
40
Never use an extension cord risk of overheating! If the power cord (6) does not
reach the nearest mains outlet, either rearrange your store layout or ask qualified
personnel to fit a new outlet.
The appliance is fitted with castors (8), so that you can easily move it from one place
to another. Warning! Do not move the appliance across uneven floors or steps.
If power is cut off, wait for at least 5 minutes before plugging the appliance in again to
avoid damaging the compressor.
Warning! Do not move the appliance across uneven floors or steps.
Important! Allow the appliance to stand upright for 8 hours before connecting to a
mains outlet for the first time, in order to allow the refrigerant to settle.
  • Page 1 1

Dukers DSP60-16-S2 Guide d'installation

Taper
Guide d'installation

dans d''autres langues