PolyScience Culinary SVC-AC1B Manuel utilisateur

USER’S GUIDE

PRECISE TEMPERATURE COOKING SYSTEM™

IMPORTANT SAFEGUARDS.

IMPORTANT: Your Sous Vide Professional is equipped

with an automatic over-temperature safety that will

disable the heater in the event of a heater fault. If this

safety cannot be reset, the unit must be sent back to

PolyScience.

!

IMPORTANT: COUNTERTOP PROTECTION

Some countertop materials may not be able to withstand

the prolonged exposure to heat required for sous vide

cooking. To safeguard against damage to your countertop,

PolyScience recommends that you always place your

cooking vessel on a trivet or other insulating material before

you begin heating the cooking liquid.

!

IMPORTANT: Your Sous Vide Professional is also equipped

with a float switch that disables the heater and pump in the

event that the liquid level in the cooking vessel drops too

low. If the Circulator will not restart once a proper liquid

level is restored, the unit must be sent back to PolyScience.

!

SAVE THESE INSTRUCTIONS.

1

Attach your Sous Vide

Professional to the

cooking vessel

2

Fill the vessel with

tap water and cover

with plastic wrap or lid

3

Connect the power cord

to an electrical outlet

4

Turn the Sous Vide

Professional “ON”

5

Press the Menu button

to access the set point

menu

Menu

Button

6

Enter desired cooking

temperature

7

Press the RUN button

Run

Button

Increase and

decrease

value buttons

IMPORTANT: The water level in

the cooking vessel will rise as

food is added. Be sure to allow

for this displacement when

placing liquid in the vessel.

!

WARNING: Make certain that the electrical outlet is

the same voltage and frequency as your Circulator. The

correct voltage and frequency are indicated on a label on

the back of the unit. The use of extension cords is not

recommended.

IMPORTANT: Always allow the cooking liquid to reach the

set point temperature before adding the sous vide cooking

pouches to the cooking vessel. For optimal heating and

performance, cover the cooking vessel with plastic wrap or

a lid (DO NOT COVER THE CIRCULATOR).

!

IMPORTANT: The cooking temperature cannot be set while

the Circulator is heating or circulating the cooking liquid.

You must first place it in Standby by pressing .

!

Setting Cooking Temperature

Cooking temperature may be set and displayed in either °F or °C.

IMPORTANT: The timer cannot be set while the Circulator

is heating or circulating the cooking liquid. You must first

place it in Standby by pressing .

!

WARNING: To avoid the potential for burns, allow the

Circulator to cool to room temperature before removing it

from the cooking vessel.

WARNING: Never immerse the Circulator’s controls or

display in water or other liquids or place under running

water. Do not clean the unit in a dishwasher.

!

Pump Impeller

WARNING: Never operate your Circulator without the

protective cover in place.

!

WARNING: To avoid the potential for burns, allow the

Circulator to cool to room temperature before removing it

from the cooking vessel.

La page charge ...

PolyScience Culinary SVC-AC1B Manuel utilisateur

PolyScience Culinary SVC-AC1B Manuel utilisateur

dans d''autres langues

Autres documents