Autel MaxiSys MS906 Pro Mode d'emploi

Taper
Mode d'emploi
     7 
A A
B B
c c
D D
E E
I
F
F
唱±
5
E
A3      7 
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End user must follow the specific operating instructions for
satisfying RF exposure compliance.
The device is designed to meet the requirements for exposure to radio waves
established by the Federal Communications Commission (USA). These requirements
set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value
reported under this standard during product certification for use when properly worn on
the body is 0.665 W/kg.
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux
CNR d'Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
1) L'appareil ne doit pas produire de brouillage;
2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Cet émetteur ne doit pas être colocalisé ou fonctionner en conjonction avec une autre
antenne ou un autre émetteur.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
Le matériel a été évalué pour répondre aux exigences générales d'exposition aux
radiofréquences.Le dispositif peut être utilisé dans des conditions d 'exposition
portables illimitées.
The device is designed to meet the requirements for exposure to radio waves
established by the Innovation, Science and Economic Development Canada's. These
requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest
SAR value reported under this standard during product certification for use when
properly worn on the body is 0.665 W/kg.
L'appareil est con?u pour répondre aux exigences d'exposition aux ondes radio établies
par l'Innovation, Sciences et Développement économique Canada. Ces exigences fixent
une limite DAS de 1.6 W / kg en moyenne sur un gramme de tissu. La valeur DAS la plus
élevée rapportée selon cette norme lors de la certification du produit pour une
utilisation lorsqu'il est correctement porté sur le corps est 0.665 W/kg.
NoteIndoor use only
  • Page 1 1
  • Page 2 2
  • Page 3 3

Autel MaxiSys MS906 Pro Mode d'emploi

Taper
Mode d'emploi

dans d''autres langues