TECHNICAL FILE
R03.001_22/04/2010
You can nd out more information about the technical features of Emac®’s products by downloading
its Technical File in www.emac.es.
If you have any query, please contact our Technical Department in tecnico@emac.es.
Technical information
www.emac.es
The data provided are for information only and have been obtained by our supplier or Emac®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
Placement
1
2 3
4
To achieve a complete nish and protection, we recommend the installation of Novolistel® 3 in vertical
edges as a complement for these Novoescia®. This listello is available with the same covering with
control of microbial deterioration. The angle pieces allow its combination, guaranteing a perfect nish
in the joints. The are also available with the same covering.
The product must be cleaned periodically with a soft cloth. If you use a neutral liquid cleaner, you must
rinse the prole with cold water and dry it to remove the humidity excess. The persistent dirtiness can
be removed by using cleaning approved agents lightly abrasive or a grid covered with polished powder
neutral. If a preserving agent is applied, as well as keep a very thin layer of water repellent, note that it
can’t be yellow,attract dust or dirt or have iridescent effects.
Steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric and
perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommended.
Citric acid is neither recommended because disolves the protective layer of the surface of aluminium.
Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes
(hydrouoroether and chlorinated solvents) and curing accelerators containing chlorides should not be
used (use special accelerators free of chlorides).
Cleaning and maintenance
Indoors Wall tiling Pavements Recyclable
Page 3 of 3
To see the video, capture
this picture with your mobile
phone (QR code reader soft-
ware is necessary) or click on
the picture.
Clean the surface destinated to the installation of Novoescocia® 4 Mini.
1. Cover generously the back face of Novoescocia® 4 Mini with an adhesive silicone type such as “MS
Sealing/Express Adhesive” from Fischer.
2. Fill also the posterior cavity with the same adhesive to ensure a perfect sealing and good grip.
3. Place the Novoescocia® 4 Mini on the corner and press rmly ensuring a good contact between
both surfaces.
4.Finally clean the remaining material and let dry.
* In humid environments or in direct touch with water, it is recommended to seal the joints between Novoesco-
cias® with silicones.