7
Inlet Hose
Connect the nut on the inlet hose to the
connector on the water valve.
Apply inlet hose to a water tap with cold,
fresh water.
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.
Drain Hose
Use the drain hose bracket to keep the end of the
drain hose retained and prevents the ou
low of
water. Don't extend the length of the drain hose; if
an extended hose is required, please consult a
serviceman.
The height of the drainage outlet must be 80-100
cm. Fix the drain hose to the clip at the back of the
washing machine to prevent it from dropping off.
The drain hose should not be submerged in water and should be securely fixed and leak-free.
If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the
washing machine will con
nuously drain while being filled (self-siphoning).
Conne
ng to Power Supply
Before connec ng to the power supply, check:
The socket is adequate for the maximum power of the washing
machine (For safety, fuses in the power circuit should be rated
for no less than 15A).
The voltage should meet the requirement.
The power outlet should be capable of accep ng the washing
machine plug.
Connect the machine to an earthed socket outlet.