Trifecte TRI-RS-8190F2 Manuel utilisateur

Taper
Manuel utilisateur
USER MANUAL
RANGE HOOD
TECHNICAL CHARACTERISTICS ..............................1
IMPORTANT SAFETY INSTRUCTIONS ...................2-3
INSTALLATION REQUIREMENT................................4
INSTALLATION PROCEDURES................................5-7
OPERATING INSTRUCTION....................................7-8
MAINTENANCE.........................................................9
TO REPLACE LIGHT ................................................9
TROUBLE SHOOTINGS............................................10
MAIN PARTS NAME ............................................11-13
CONTENTS
READ AND SAVE THESE INSTRUCTIONS MANUAL
Please note that this product is marked with this symbol:
According to Wsate of Electrical and Electronic Equipment
(WEEE) directive, WEEE should be separately collected and
treated. If at any time in future you need to dispose of this
product, Please dp NOT dispose of this product with house hold
waste. Please send this productto WEEE collecting points where
available
Dear consumer,
Thanks for your purchase of our range hood and we hope
we can fully satisfy all of your needs. Please read the entire
instructions carefully before proceeding to obtain the best
results of operation the range hood.
Model number: TRI-RHRS8190F2
TRI-RHRS8175F2
Total power: 208W
Motor power: 200W
LED Lights: 4x2W
Voltage: 110~127V
Frequency: 60Hz
Filter: Aluminum filter
Baffle filter
Control: Touch Control
Hanger
Glass
light
light
Wear
electrical shock.
range
INSTALLATION:
USE ONLY WITH RANGE HOOD CORD CONNECTION KITS THAT HAVE BEEN
INVESTIGATED AND FOUND ACCEPTABLE FOR USE WITH THIS MODEL
RANGE HOOD. A UTILISER SEULEMENT AVEC UNE TROUSSE DE
RACCORDEMENT DE CORDON DE HOTTE VERIFIEE ET APPROUVEE
POUR EMPLOI AVEC CE MODELE DE HOTTE.
range
range
make sure
range
NOT LEVELNOT LEVEL
CORRECT
NOT CORRECT
8
Hanger
Hanger
16
16
nuts
Use 16pcs m4 screws to fix the hangers
197
Light Timer Speed down Speed up Max speed On/off
Turn on and turn off the light
Set time
Speed down, from speed 3 to speed 1
Speed up, from speed 1 to speed 3
To start max speed
To turn on and turn off the power
Time setting: Press for approximately 3 seconds.
Touch (Speed up) to set hour.
Touch (Speed down) to set minute.
1.How to use the Touch Control
Press to turn on /off the light.
Press to select the high speed.
Press to select the medium speed.
Press to select the low speed.
Press to select on/off.
range
light
the range
light
LED light
light
light
light.
light
Light
WARNING – TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on low or medium settings.
b) Always turn hood ON when cooking at high heat or when flambeing food (i.e.Crepes Suzette,
Cherries Jubilee, Peppercorn Beef Flambe).
c) Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
d) Use proper pan size. Always use cookware appropriate for the size of the surface element.
WARNING – TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE
TOP GREASE FIRE, OBSERVE THE FOLLOWING: SMOTHER FLAMES with a close-tting lid,
cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS.
If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
b) NEVER PICK UP A FLAMING PAN – You may be burned.
c) DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosion will result.
d) Use an extinguisher ONLY if:
1) You know you have a Class ABC extinguisher, and you already know how to operate it.
2) The fire is small and contained in the area where it started.
3) The fire department is being called.
4) You can fight the fire with your back to an exit.
WARNING: TO PROVIDE PROTECTION AGAINST ELECTRIC SHOCK, CONNECT TO
PROPERLY GROUNDED OUTLETS ONLY.
A UTILISER SEULEMENT AVEC UNE TROUSSE DE RACCORDEMENT DE CORDON DE
HOTTE VÉRIFIÉE ET APPROUVÉE POUR EMPLOI AVEC CE MODÈLE DE HOTTE.
WARNING - To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any
Solid-State Speed Control Device. AVERTISSEMENT : NE CONVIENT PAS A DES
REGULATEURS DE VITESSE A SEMI-CONDUCTEURS.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current. This
appliance is equipped with a cord having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed and grounded.
WARNING – Improper grounding can result in a risk of electric shock.
Consult a qualied electrician if the grounding instructions are not completely understood,
or if doubt exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualied electrician
install an outlet near the appliance
CONSIGNES DE MISE A LA TERRE
Cet appareil doit être mis à la terre. En cas de court-circuit, le fil de mise à la terre limite le
risqué de choc électrique parce quil assure le retour du courant à la terre. L’appareil est
livré avec un cordon muni dun fil de terre et dune fiche de mise à la terre, qui doit être
branchée sur une prise mise à la terre correctement installée.
AVERTISSEMENT — Une mise à la terre incorrecte peut entraîner des risques de choc
électrique. Consulter un électricien compétent en cas de doute sur ces consignes de mise
à la terre ou en cas dincertitude concernant la mise à la terre correcte du circuit sur lequel
lappareil est branché.
Ne pas utiliser de cordon de rallonge. Si le cordon dalimentation est trop court, faire installer
une prise par un électricien compétent à proximité de lappareil.
WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT WORK.
CAUTION: Disconnect the power supply before servicing.
STATUS
CAUSE & METHOD OF REPAIRING
TOOL
The power
supply is
damaged
If the power supply is damaged, please call
the technician to repair.
Screwdriver
The motor
does not run
A). The fan was blocked, check the fan make
sure it is in the correct place.
B). The motor was blocked, check the motor
and make sure it’s in the correct place.
C). The motor was broken, replace a new one.
D). The switch was broken, replace a new one.
E). The capacitor was broken, replace a new one.
Screwdriver
The unit
body shake
A). The installation is not firm enough.
Check it and make sure the hood is firm enough.
B). The fan is broken, so it’s no balance.
Replace a new one.
C). The installation of the blower is not correct.
Check it and install it correctly.
D). The motor does not firm enough.
Check it and install it firmly enough.
Screwdriver
Screwdriver
Screwdriver
Big noise
A). The blower is no in balance. Adjust the fan fix
screws to balance or replace a new one.
B). Some other things drop to the blower.
Check and clean it.
Suction not
so powerful
A). The distance from the range hood to the gas
cooker is too big, make sure the distance is
about 600-700mm.
B). There are many windows or doors in the
kitchen, the air convection is too big. Close
some doors or windows to make the air
convection smaller.
C). There is some other pour wind to the
exhaust pipe. Make the exhaust pipe’s exit
to downwards.
D). The run rate of motor decrease obviously.
Replace a new motor or capacitor.
Because of the range hood is set upon one
board on the back of the range hood for
covering the hollow of the window.
Led light
does not work
Replace a new LED light assembly.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Trifecte TRI-RS-8190F2 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues