OM-1077 Page 2
. Remove paint from axle
grooves (13) before installing
retaining rings (8).
Ref. 144021 / 145362
B
B
1
2
3
4
5
6
13
7
8
9
10
6
12
3
2
1
15
16
17
18
6
11
19
20
21
14
15
1 602101 Screw, 10-24 x 5/8 (4)
1 112277 Screw, 10-24 x 2 (4)
2 602203 Washer, No. 10 lock (4)
3 602238 Washer, 3/16 flat (4)
601861 Nut, 10-24 (4)
4 146296 Stand-Off, No. 10-24 x
1-9/16 (4)
4 601861 Nut, 10-24 (4)
5 604126 Screw, 1/2-13 x 1 (2)
6 602247 Washer, 1/2 flat (6)
7 097455 Wheel, 8 in (2)
8 121614 Retaining Ring (2)
9 603995 Washer, 3/4 flat (2)
10 601879 Nut, 1/2-13 (2)
11 602216 Washer, 1/2 lock (4)
12 255489 Axle Mounting Bracket (2)
13 135390 Axle (1)
14 601959 Screw, 5/16 x 1-1/2 (4)
15 604538 Washer, 5/16 flat (8)
16 602211 Washer, 5/16 lock (4)
17 604537 Nut, 5/16-18 (4)
18 123557 Caster, 5 in (2)
19 124115 Nut, 7/16-14 (2)
20 144020 Base (1)
21 144018 Handle (1)
Be sure to provide Model when ordering re-
placement parts.
Description (Qty)
Part
No.
Item
No.
AB
C
A
ABA
C
C
D
D
D
Top View Of Cart Base
11
Tools Needed:
5/16, 1/2, 9/16, 3/4 in.
. For S-60, S-70 and 20 series feeders, install stand-offs (4) in holes labeled A, and secure
with four 10-24 x 5/8 in. screws (1), washers (2), and 3/16 in. flat washers (3).
For D-60 series, install stand-offs (4) in holes labeled B, and secure with four 10-24 x 5/8
in. screws (1), washers (2), and 3/16 in. flat washers (3).
For S-22A, install stand-offs (4), in holes labeled C, and secure with three 10-24 x 5/8 in.
screws (1), washers (2), and 3/16 in. flat washers (3).
For 22A, 24A feeders, install stand-offs (4), in holes labeled D, and secure with three 10-24
x 5/8 in. screws (1), washers (2), and 3/16 in. flat washers (3).
For 50 series, line up holes in feeder base with holes in cart labeled A, and secure with
four 10-24 x 2 in. screws (1), washers (2), 3/16 in. flat washers (3), and 10-24 in. nuts (4).