Warning
1. Don't place the product into a liquid environment or avoid the product exposed to
high humidity.
2. Avoid extrusion to avert the damage to the product.
3. Don't attempt to dismantle the product. Put the product in a cool and dry place to
keep it dry if stored for a long time.
4. Avoid touching the strong magnet to prevent the magnetic headset from being
demagnetized.
5. Avoid the dusty, wet and dirty environment where the electronic circuit of the
equipment may be damaged if being used.
6. Don't use the equipment at the moment of thunderstorm because the thunderstorm
may incur equipment fault or shock hazard.
7. Don't use the equipment when riding a motorcycle or a bicycle, driving a car or
crossing the road to ensure your safety.
8. Keep the equipment out of reach of children or pets to avert the damage.
9. Don't wash the equipment with chemical, cleanser or strong detergent.
Don't listen to the voice under high sound pressure and high volume for a long
time to prevent the possible hearing impairment when the headset is used.
Battery warning
The built-in lithium battery of the product is forbidden to be disassembled, impacted,
extruded or put into fire. The battery under the very low air pressure may result in
explosion or flammable liquid or gas leakage. Avoid the battery in a high-temperature
environment or being exposed to strong sunlight to avert explosion. Don't use the
battery continuously in case of serious ballooning. The battery shall be handled
pursuant to the local regulations and shall not be disposed as household garbage.
Don't try to repair, remove or refit the battery. The explosion may happen if the battery
is replaced by the one subject to incorrect model. Don't compress or puncture the
battery with hard object. The battery leakage, overheating or outbreak of a fire may
occur if the battery is destroyed.
This symbol means that aocorcing to looal laws and regulations your product and/or
its battery shall be disposed of separately from household waste. When this product
reaches its end of life, user has the choice to give his
WEEE
product to a competent recycling organization. Proper recycling of your product will
protect human health and the environmerrt.
Hereby, realme, declares that this device is in compliance with the essential
requirements and other relevant provisions of Radio Equipment Directive
2014/53/EU. The declaration of conformity may be consulted at www.realme.com/-
global/sup-port/eu-declaration
RF exposure information: The EIRP power of the device at maximal case is below the
exempt condition, 20mW specified in EN62479: 2010. RF exposure assessment has been
performed to prove that this unit will not generate the harmful EM emission above the
reference level as specified in EC Council Recommendation(1999/519/EC).
Caution risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
Excessive sound pressure from earphones and headphones can cause hearing loss.
Due to the used enclosure material, the earphone shall only be connected to a USB
Interface of version 2.0 or higher. The connection to so called power USB is prohibited.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
- This device and its antenna(s) must not be co-located or operating in conjunction with
any other antenna or transmitter.
FCC ID :2AUYFRMA2003
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
Or
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
This equipment complies with ISED RF radiation exposure limits set forth for an
uncontrolled environment
L 'appareil correspond à une limite d' exposition au rayonnement radiofréquence d 'Ed
pour un environnement non contrôlé
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1)this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
This class B digital applicats complies with Canadian ICES-003.
This class B digital equipment meets the Canadian nmb-003 standard.
Cet appareil est conforme avec Industrie Canada RSS exemptes de licence standard(s).
Son fonctionnement est soumis aux deux conditions suivantes:
(1)cet appareil ne peut pas provoquer d'interférences,
et (2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un
mauvais fonctionnement de l'appareil.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
CUSTOMER CARE:
Manager-Customer Care:
Realme Mobile Telecommunications (India) Private Limited
Address: 3rd Floor, Tower B, Building Number 8, DLF Cyber City,
Gurugram-122002, Haryana, India
Email: service@realme.com
Website: www.realme.com
Toll Free: 1800 102 2777
Manufactured By: Realme Chongqing Mobile Telecommunications Corp., Ltd.
Address: No. 178 Yulong Avenue, Yufengshan, Yubei District,
Chongqing,China
Imported By: OPPO Mobiles India Private Limited
Address: 5th Floor, Tower B, Building Number 8, DLF Cyber City,
Gurugram-122002, Haryana, India
Country Of Origin: China
CN
TW
EN
ID
VN
TH
MM
KSR
IL
ISR
POR
RUS
CN
TW
EN
ID
VN
TH
MM
KSR
IL
ISR
POR
RUS
CN
TW
EN
ID
VN
TH
MM
KSR
IL
ISR
POR
RUS
CN
TW
EN
ID
VN
TH
MM
KSR
IL
ISR
POR
RUS
CN
TW
EN
ID
VN
TH
MM
KSR
IL
ISR
POR
RUS
CN
TW
EN
ID
VN
TH
MM
KSR
IL
ISR
POR
RUS
CN
TW
EN
ID
VN
TH
MM
KSR
IL
ISR
POR
RUS
-
1
