capello CR15 Manuel utilisateur

Marque
capello
Modèle
CR15
Catégorie
Équipement musical supplémentaire
Taper
Manuel utilisateur
CR15 user guide
IMPORTANT SAFETY INSTRUCTIONS
SAFETY PRECAUTIONS
a. Do not expose this unit or the AC adaptor to dripping or splashing water. Keep liquid-lled
objects, such as vases, away from this unit and AC adaptor.
b. To ensure that this unit is completely disconnected, unplug it from the wall.
c. Ensure that the AC adaptor is easily accessible.
d. Please note the information printed underneath the unit.
e. Batteries should not be exposed to excessive heat such as direct sunshine, re, etc.
f. Do not impede the ventilation of this unit by covering the ventilation openings with items such
as newspapers, table-cloths, curtains, etc.
g. Keep open ames, such as lighted candles, away from this unit.
h. Do not place this unit in closed bookcases, racks, or other spaces without proper ventilation.
i. Use only the same or equivalent type batteries as there is a danger of explosion if the incorrect
batteries are used or they are installed incorrectly.
j. Dispose of batteries properly according to environmental regulations.
Some of the following information may not apply to your particular product; however, as with any electronic
product, precautions should be observed during handling and use.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding-type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your safety. When the provided plug does
not t into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11. Only use attachments/accessories specied by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
WARNING: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE
LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISES ET POUSSER JUSQU’AU FOND.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
SURGE PROTECTORS: It is recommended to use a surge protector for AC connection. Lightning
and power surges ARE NOT covered under warranty for this product.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Compliance information: This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
DANGEROUS VOLTAGE: The lightning ash with arrowhead symbol, within an equilateral
triangle is intended to alert the user to the presence of uninsulated dangerous voltage
within the product’s enclosure that may be of sufcient magnitude to constitute a risk of
electric shock to persons.
ATTENTION: The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
power source
Plug in the AC power adaptor to a wall
outlet providing 120V AC, 60Hz.
The output of the provided AC power
adaptor is AC 7.5V 100mA.
notes: Disconnect the AC power
adaptor when not in use.
replacing the battery
u Open the battery door by pushing in on the tabs, then removing the door.
v Insert two (2) “AAA” batteries following the correct polarity indicated in
the battery compartment.
w Replace the battery door back on the compartment.
notes: The batteries are used to backup the clock and alarm times
when the AC adaptor is disconnected or there is a power failure.
Alkaline batteries are recommended for the longest backup time.
When replacing the battery, do not disconnect the AC power adapter
otherwise the current time, alarm, and station presets will be erased.
AC outlet
AC power adapter
backup battery
To keep accurate time, this unit uses (2) “AAA” batteries (sold separately)
for clock backup. These batteries keep the clock operating in the event of
a power interruption.
when to replace the battery
The battery indicator will illuminate on the display when there are no
batteries or when the batteries are low.
inside the box
CR15 Alarm Clock Radio and user guide.
batter y precautions:
Follow these precautions when using batteries in this device:
u
Warning - Danger of explosion if batteries are incorrectly replaced.
Replace only with the same or equivalent type.
v
Use only the size and type of batteries specied.
w
Be sure to follow the correct polarity when installing the batteries as
indicated in the Battery Compartment. A reversed battery may cause
damage to the device.
x
If the device is not to be used for a long period of time, remove the
batteries to prevent damage or injury from possible battery leakage.
y
Do not try to recharge a battery not intended to be recharged - it can
overheat and rupture. (Follow battery manufacturer’s directions.)
U
Do not mix different types of batteries together (e.g. Alkaline,
Rechargeable and Carbon-zinc) or old batteries with fresh ones.
Sleep
Easy
Alarm Clock
AM/FM Radio
setting the clock
u
Plug in the unit.
v
Press and hold the TIME SET button until the clock ashes in the display.
w
Press the TUNE DOWN / HOUR button repeatedly to set the hour and press the
TUNE UP / MIN button repeatedly to set the minute.
x
Press the TIME SET button again to store the new clock setting.
note: If you do not press any button for about 10 seconds while setting the clock,
the clock setting will be canceled.
playing the radio
u
With the CR15 plugged in and powered ‘ON’, press TIME SET / BAND button to
select FM or AM band.
v
Repeatedly press the TUNE UP / MIN or TUNE DOWN / HOUR button to manually
adjust the tuning on the display until the desired station appears.
w
For auto tuning, press and hold the TUNE UP / MIN or TUNE DOWN / HOUR
button until the display starts to scan then release the button and the tuner will
search and stop on the next strongest station it nds. Repeat this process until
the desired station appears on the display.
notes: Fully extend the FM wire antenna to increase reception sensitivity.
Keep digital music players or mobile phones away from the FM antenna as this
may cause interference. Do not place the FM antenna near the AC power adaptor
as this may lead to reception interference.
setting radio presets
u
To preset a radio station to memory, rst follow the steps above to tune in the
desired station.
v
Press and hold the ALARM SET / PRESET button to create a preset for the current
station. “P” will appear and “##” (the preset number) will blink on the display.
w
Press the TUNE UP / MIN or TUNE DOWN / HOUR button to select a preset
number (01- 10). Press the ALARM SET / PRESET button again to conrm the
setting and the station will be saved into memory.
x
Repeat these steps for up to 10 presets, as desired.
note: Saving a new station preset in the same position as a previously saved
station will replace the previously stored station for that preset number.
recalling radio presets
To recall saved presets, repeatedly press the ALARM SET / PRESET button until the
desired preset number appears in the display and the unit tunes to the station.
setting the alarm
u
In STANDBY mode, press and hold the ALARM SET / PRESET button, the alarm
time will ash.
v
Press the TUNE DOWN / HOUR or TUNE UP / MIN button to set the alarm time.
w
Press ALARM SET / PRESET button to conrm the alarm time set.
x
Alarm source indicator (default as alarm radio) will blink on the display. Press TUNE
DOWN / HOUR or TUNE UP / MIN button to set the desired alarm source (Chime or
Radio). The indicator of the selected alarm source will blink on the display.
y
Press ALARM SET / PRESET button to conrm the alarm source set, the volume level
will blink on the display (there is no volume setting if alarm source is set to Chime).
U
Press TUNE DOWN / HOUR or TUNE UP / MIN button to set maximum alarm volume.
V
Press ALARM SET / PRESET button to conrm the alarm set and the alarm
indicator will appear on the display.
notes: To deactivate the alarm, press ALARM SET / PRESET button, the alarm
indicator will turn off.
Before setting the alarm, make sure that the clock is set correctly
(see “Setting the clock”).
silencing the alarm
When the alarm sounds, press ALARM SET / PRESET button to silence the alarm.
snooze
u
When alarm sounds, pressing the SNOOZE / SLEEP button will temporarily
silence the alarm. The alarm will sound again after approximately 10 minutes.
v
To extend the snooze duration, repeatedly press the SNOOZE / SLEEP button to
cycle through and select one of the snooze presets:
10 20 30 40 50 6 0
notes: Once the snooze function has been activated, press the SNOOZE / SLEEP
button anytime and the display will show the remaining time.
Repeatedly press the SNOOZE / SLEEP button to adjust or modify the current
snooze time setting.
setting the sleep timer
The CR15 features a sleep timer to allow you to fall asleep to the radio using the
built-in sleep timer to automatically turn off the radio.
u
When the unit powered ‘ON’, press the SNOOZE / SLEEP button. The SLEEP
icon and “15” will appear on the display briey indicating the unit will turn off
after 15 minutes.
v
To increase the sleep time duration, up to a maximum of 90 minutes,
repeatedly press the SNOOZE / SLEEP button to select one of the following
sleep time presets:
15 30 60 90 OFF
w
With the sleep timer active, press SNOOZE / SLEEP button once to view the
remaining sleep time.
x
To cancel the sleep timer function, repeatedly press the SNOOZE / SLEEP
button until “OFF” appears in the display.
location of controls
u
Speaker
v
FM Antenna Wire
w
ALARM SET / PRESET
x
Power ON / OFF
y
TUNE UP / MINUTE
U
TUNE DOWN / HOUR
V
SNOOZE / SLEEP
W
LED Display
X
Battery Compartment (bottom)
at
VOLUME +
ak
VOLUME –
al
TIME SET / BAND (AM/FM)
am
AC Power Adaptor
an
ALARM ‘Radio’ Indicator
ao
ALARM ‘Chime’ Indicator
ap
Low Battery Indicator
aq
PM Time Indicator
ar
LED Display
as
SLEEP Indicator
1
For further assistance, please visit our website at hellocapello.com
or contact customer service at suppor[email protected] or 1-855-896-1795
Life Lab International Ltd.
specifications
GENERAL:
Power Source ...................................................................... AC 7.5V 100mA AC/AC Adapter
AC Power Supply ............................................................................................120V ~ 60Hz
Battery Backup ........................................................................ 2 x 1.5V “AAA” size batteries
RADIO SECTION:
Frequency Range (FM) ................................................................................87.5 – 108 MHz
Frequency Range (AM) .............................................................................. 530 – 1710 KHz
Specications are subject to change without notice.
3
2
13
14
16
15
7
17
4
5
6
12
11
10
9
8
19
18
  • Page 1 1
  • Page 2 2

capello CR15 Manuel utilisateur

Marque
capello
Modèle
CR15
Catégorie
Équipement musical supplémentaire
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents