Otterbox OBFTC-0094-A Mode d'emploi

Taper
Mode d'emploi
OtterBox Charging Pad
OBFTC-0094-A, 78-80537, 78-80563,
78-80632, and 78-80633
OtterBox Charging Pad
02
Charging Pad
03
04
05
06
https:/www.otterbox.com
56.0x56.0x5.6mm
5Wireless 15W (Max)
5V/3A 9V/2.22A 12V/1.67A
61.0g
Manufacturer:
Company Name: DONGGUAN KETAIHONG ELECTRONICS CO.,LTD
Address : Second Industrial Zone, Shujiu Village, Changping Town,
523569 Dongguan, Guangdong, PEOPLE'S REPUBLIC OF CHINA
7
35
WARING Do not hang any type of accessory or accessory bracket from the plug
07
FCC Statement
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Non-modification Statement:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body. 08
ISED Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Radiation Exposure Statement
This equipment complies with Canada radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 10cm between the radiator & your body.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d'Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes :
(1) L'appareil ne doit pas produire de brouillage;
(2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est
susceptible d'en compromettre le fonctionnement.
Déclaration d'exposition aux radiations
Cetéquipementestconforme Canada limitesd'exposition aux radiations dans un
environnement non contrôlé. Cetéquipementdoitêtreinstallé et utilisé à distance
minimum de 20cm entre le radiateur et votre corps.
09
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Otterbox OBFTC-0094-A Mode d'emploi

Taper
Mode d'emploi

dans d''autres langues