Location
Refer to the installation
instructions for the installation.
This appliance is not intended to be used
as a built-in appliance.
In case of different installation from
freestanding respecting space required in
use dimensions, the appliance will
function correctly but energy consumption
might increase slightly.
To ensure appliance's best functionality,
you should not install the appliance in the
nearby of the heat source (oven, stoves,
radiators, cookers or hobs) or in a place
with direct sunlight. Make sure that air can
circulate freely around the back of the
cabinet.
This appliance should be installed in a dry,
well ventilated indoor position.
To ensure best performance, if the
appliance is positioned below an
overhanging wall unit, the minimum
distance between the top of the cabinet
shall be maintained. Ideally, however, the
appliance should not be positioned below
overhanging wall units. One or more
adjustable feet at the base of the cabinet
ensure that the appliance stands level.
CAUTION! If you position the
appliance against the wall, use
back spacers provided or keep
the minimum distance indicated
in the installation instructions.
CAUTION! If you install the
appliance next to a wall, refer
to the installation instructions to
understand the minimum
distance between the wall and
the side of the appliance where
door hinges are to provide
enough space to open the door
when the internal equipment is
removed (e.g. when cleaning).
This appliance is intended to be used at
ambient temperature ranging from 10°C to
43°C.
The correct operation of the
appliance can only be
guaranteed within the specified
temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer service
or to the nearest Authorised
Service Centre.
It must be possible to
disconnect the appliance from
the mains power supply. The
plug must therefore be easily
accessible after installation.
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
Door reversibility
If you want to change the opening
direction of the door, contact the nearest
Authorised Service Centre. The
Authorised Service specialist will reverse
the door swing at your cost.
7