80822476 IFTBD400
Installing the interface board
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.”
Federal Communications Commission Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.
This statement will be applied only for the printers marketed in U.S.A.
Statement of The Canadian Department of Communications Radio Interference Regulations
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A
prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.
The above statement applies only to printers marketed in Canada.
The interface board is an option for the compact size thermal printer
TSP400/TUP400 series. When installing the interface board, please use
the following procedure.
Interface Board Applicable printer
IFTBD400D
........
RS
-
232C TSP412
.......
without auto cutter
IFTBD400C
.........
Parallel TSP442
.......
with auto cutter
IFTBD400K
........
RS
-
422A TUP452
.......
without presenter
TUP482
.......
with presenter
IFTBD400V2D
...
RS
-
232C TUP492
.......
with document capture
IFTBD400V2C
....
Parallel TUP452V2
..
without presenter
IFTBD400K
........
RS
-
422A TUP482V2
..
with presenter
Installation
(
TSP400 Series
)
1. Make sure that the power cord is unplugged.
2. Remove the interface cover of the printer.
Note: No screws have been used.
3. Position the interface board in the PCB guide as shown in the
illustration, so that the components on the interface board face
upwards. Slide the interface board in until it is firmly seated.
Note: Insert the interface board so that it connects with the
connector.
4. Secure the interface board using the three screws.
5. Replace the interface cover firmly.
Installation
(
TUP400 Series
)
1. Make sure that the power cord is unplugged.
2. Insert the interface board so that it connects with the connector of the
control board in the printer.
3. Secure the interface board using two screws.
Printer
Interface board PCB guide
Connector
Interfaceboard
Screws(3)
Interface cover
Connector
Interface board
Screws(2)
-
1
Star Micronics TUP452V2 Install Manual
- Taper
- Install Manual
- Ce manuel convient également à
dans d''autres langues
- English: Star Micronics TUP452V2
Documents connexes
-
Star Micronics TSP400Z Manuel utilisateur
-
-
Star Micronics TSP700 Series Replacement
-
-
-
-
-
