Honeywell RCW25 Manuel utilisateur

Taper
Manuel utilisateur
RCW35 and RCW25 Series (51366SL)
Decorative Wired Chimes
RCW250N, RCW251N, RCW35N,
RCW3501N, RCW3502N, RCW3503N,
RCW3504N, RCW3505N, RCW3506N
69-2173EFS-03
Installation
Instructions
69-2173EFS_B.indd 1 4/17/2008 11:15:45 AM
This is a legacy product document
supported by Resideo. It is no
longer manufactured
69-2173EFS—03 ii
Installation Instructions
Contents
Safety ............................................................................................................................................. 3
Checking pack contents ............................................................................................................... 4
Installation ..................................................................................................................................... 5
Power supply ................................................................................................................................ 6
Mount the chime ........................................................................................................................... 7
Wiring - transformer powered ...................................................................................................... 8
Wiring - battery powered ............................................................................................................ 10
Operate Push .............................................................................................................................. 11
Volume control ............................................................................................................................ 11
Change tunes .............................................................................................................................. 12
Program button ........................................................................................................................... 14
Finishing the wood cover ........................................................................................................... 15
Specifications .............................................................................................................................. 16
Troubleshooting .......................................................................................................................... 17
Disposal and recycling ............................................................................................................... 18
Guarantee .................................................................................................................................... 18
Declaration .................................................................................................................................. 18
69-2173EFS_B.indd 2 4/17/2008 11:15:45 AM
RCW35 Series and RCW25 Series
1 69-2173EFS—03
M27254
M27274
TUNE
BUTTON
PROGRAM
BUTTON
CHANNEL INDICATOR LED
WIRED CHIME BASE
VOLUME CONTROL
LOW
BATTERY
LED
WIRE CONNECTION
PORT/TERMINAL
HOLE FOR
CABLE/WIRE ENTRY
DECORATIVE CHIME COVER
SOLD SEPARATELY FROM
RCW35N
OPTIONAL POWER
WITH FOUR x LR14C
ALKALINE BATTERIES
69-2173EFS_B.indd 1 4/17/2008 11:15:45 AM
69-2173EFS—03 2
Installation Instructions
Compatible with most bell pushes, with standard normally open contacts, including
Honeywell wired pushes marked with “B.”
Can work with up to 3 push circuits.
Illuminated bell push buttons can be used when the chime is powered by a trans-
former (Honeywell RCA900N).
69-2173EFS_B.indd 2 4/17/2008 11:15:45 AM
RCW35 Series and RCW25 Series
3 69-2173EFS—03
Safety
Before proceeding with the installation, please note the following safety warnings:
Always follow the manufacturer’s advice when using power tools and wear
suitable protective equipment (e.g. safety goggles) when drilling holes, etc.
Before drilling holes in walls, check for hidden electricity cables and water pipes.
The use of a cable/pipe locator is advisable if in doubt.
Chime is for indoor use only.
Avoid mounting location which can expose chime to splashing or dripping liquid.
Use UL approved transformer for connection to mains.
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat
such as sunshine, fire or the like; danger of damage if battery is incorrectly replaced.
Replace only with the same or equivalent type.
69-2173EFS_B.indd 3 4/17/2008 11:15:45 AM
69-2173EFS—03 4
Installation Instructions
Chime
2 x fixing screws for chime
2 x wall plugs
You will need:
Wired push
20 AWG minimum bell wire
4 mm cross-head screwdriver
A small flat bladed screwdriver
1/4-in. (6 mm) masonry drill bit
4 x LR14 ‘C’ Alkaline batteries OR
transformer (16V 10 VA) Honeywell
part number RCA900N
Checking Pack Contents
69-2173EFS_B.indd 4 4/17/2008 11:15:45 AM
RCW35 Series and RCW25 Series
5 69-2173EFS—03
Installation
1. Open the chime cover
M27275
69-2173EFS_B.indd 5 4/17/2008 11:15:45 AM
69-2173EFS—03 6
Installation Instructions
Power Supply
2. Determine the type of power supply and type of wired push required to suit your
installation. Use 4 x LR14 ‘C’ size alkaline batteries; OR a 16V, 10VA transformer
as recommended in the table below below:
T
ATTENTION!
ATTENTION!
12
16 V~
¡ATENCIÓN!
M27276
3
69-2173EFS_B.indd 6 4/17/2008 11:15:45 AM
RCW35 Series and RCW25 Series
7 69-2173EFS—03
Mount the Chime
3. Mounting holes are marked with a screw symbol.
2 M
6 FT
M27250
69-2173EFS_B.indd 7 4/17/2008 11:15:45 AM
69-2173EFS—03 8
Installation Instructions
Connect the wires from door push and trans-
former (where used) to the chime terminals as
detailed in step 4. The wires can be surface
mounted or direct from opening in the wall
and enter the rear of the chime housing using
the wire guide channels provided.
4a. Transformer powered - Wiring for
standard/lighted push via a 16V 10VA
transformer.
Wiring
69-2173EFS_B.indd 8 4/17/2008 11:15:45 AM
RCW35 Series and RCW25 Series
9 69-2173EFS—03
120V~
16V~
C3
C2
16V~
120V~
C1
V/AC
AC
3
2
1
x 1
M27280
x 3
OPTION 2: SERIES AC CONNECTION
REQUIRED BATTERIES
Note: Wire/cable
length should not
exceed 150 ft. (50 m).
69-2173EFS_B.indd 9 4/17/2008 11:15:45 AM
69-2173EFS—03 10
Installation Instructions
x 1
C3
C2
C1
V/AC
AC
3
2
1
M27281
x 3
4b. Battery powered - Wiring for
standard (non-lighted) push only.
Note: Wire/cable length should not
exceed 150 ft. (50 m).
69-2173EFS_B.indd 10 4/17/2008 11:15:46 AM
RCW35 Series and RCW25 Series
11 69-2173EFS—03
Operate Push
5. Chime will play the default tune. The
associated channel LED will illuminate.
6. To adjust volume.
M27277
69-2173EFS_B.indd 11 4/17/2008 11:15:46 AM
69-2173EFS—03 12
Installation Instructions
To Change Tune
7. Chime tunes are provided plus an additional alert tone.
Tunes Table
Ding Dong
St Clements
Westminster
Tube Chime
Warm Brass
Fantasy
!Alert
69-2173EFS_B.indd 12 4/17/2008 11:15:46 AM
RCW35 Series and RCW25 Series
13 69-2173EFS—03
Press push button, chime will play tune, while the
Channel LED on chime is flashing, press and release
tune button . Press and release button again to
cycle through the available tunes until you hear the
tune you want to play.
The last tune played will be stored after Channel LED
stops flashing.
To confirm, press the push button and chime will play
tune you want.
M27278
!
69-2173EFS_B.indd 13 4/17/2008 11:15:46 AM
69-2173EFS—03 14
Installation Instructions
Program Button
8. The Program button can be used to:
Change the tune of the associated push without pressing the push button.
Press and hold the program button l. The channel LED will illuminate in
sequence. Release the program button when channel LED for the related push
illuminates. The chime will play the latest tune, channel LED will flash. While
channel LED is flashing, tune can be changed using the tune select button .
Recall
A short push of the program button l will flash the Channel LED linked to the
last push that was used.
69-2173EFS_B.indd 14 4/17/2008 11:15:46 AM
RCW35 Series and RCW25 Series
15 69-2173EFS—03
9. Clip on the front cover.
10. For customizable wood covers only:
Choose your paint, wood stain/
varnish or wall paper and then apply
to the cover. Follow manufacturers’
advice on the paint/vanish.
It is possible to unscrew the four
screws shown below for finishing.
Ensure you screw it back with the
same screws provided!
Once completed, clip it onto the
base.
M27251
69-2173EFS_B.indd 15 4/17/2008 11:15:46 AM
69-2173EFS—03 16
Installation Instructions
Specification Chime
Operating Temperature 32°F to 104°F
0°C to +40°C
Sound Level (typical) 90dBA @ 3 ft (1m)
Power Supply 4 x LR14 C size alkaline batteries
OR
16V 10VA transformer (UL approved) Honeywell part number
RCA900N
Battery Life (if applicable)
(5 operations/day) 12 months
69-2173EFS_B.indd 16 4/17/2008 11:15:46 AM
RCW35 Series and RCW25 Series
17 69-2173EFS—03
Troubleshooting
When the illuminated bell push is operated, very dim / no light appears on the push…
Check the power supply. You should use a 16V 10VA transformer connection for an illuminated
push. Follow step 4.
The chime does not work…
Check that the wiring is done correctly according to step 4, using minimum 20AWG wire.
If using batteries:
Check that the batteries are the correct type, LR14 ‘C’ cells. Only use alkaline batteries.
Check that the batteries are fitted correctly (with correct polarity).
Check that batteries are not too low.
The chime does not sound…
Check that the volume control is not at the minimum setting.
Low battery light flashes…
When the chime battery is low, an amber LED located at the side of the chime will flash. Install
new batteries in the chime, type LR14 ‘C’ cells. Only use alkaline batteries.
The icons keep on flashing…
The push associated with the icon is stuck. Check the push.
69-2173EFS_B.indd 17 4/17/2008 11:15:46 AM
69-2173EFS—03 18
Installation Instructions
Disposal & Recycling
Batteries and waste electrical products should not be disposed of with household waste. Please
recycle where these facilities exist. Check with your local authority or retailer for recycling advice.
Guarantee
Honeywell guarantees this product for 1 year from the date of purchase. Proof of purchase is
required; this does not affect your statutory rights. If you require further information about your
product, call the Honeywell helpline at 1-800-468-1502.
Declaration
Honeywell hereby declares that this product complies with Part 15 of the FCC rules and
Industrial Canada standards. This device operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Caution:
Changes or modification not expressly approved by the party responsible for regulatory compli-
ance could void the user’s authority to operate the equipment.
The Class B digital apparatus complies with Canadian IECS-003. Cet appareil numérique de la
class B est conforme á la norme NMB-003 du Canada.
69-2173EFS_B.indd 18 4/17/2008 11:15:46 AM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58
  • Page 59 59
  • Page 60 60
  • Page 61 61
  • Page 62 62
  • Page 63 63
  • Page 64 64
  • Page 65 65
  • Page 66 66
  • Page 67 67
  • Page 68 68

Honeywell RCW25 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues