Powercast PCR91501 Manuel utilisateur

PCR91501
Marque
Powercast
Modèle
PCR91501
Taper
Manuel utilisateur
User Manual
PCR91501 – Powercast RFID Reader
Powercast products and technology are covered by one or more patents with other patents pending. All patent and trademark information
can be found at http://www.powercastco.com/IP/.
Rev 1.4 – 2022/09 User’s Manual – PCR91501 Transmitter Page 1
www.powercastco.com
PRODUCT DESCRIPTION
The Powercast PCR91501 is a UHF RFID
Reader. It is designed to communicate and
power RFID tag devices. The tag device
communicates back to the reader via RF
backscattering. The backscatter
communication eliminates the need for a
separate radio on the tag device and enables
the detection and identification of the tag
device. The tag device also has the ability to
send back pertinent information to the
reader, such as sensor data or charge level.
This information is accessible via the USB-C
port on the reader. The reader operates in
the 902-928MHz ISM frequency band and is
housed in a durable plastic case.
Operational power as well as
communication is provided to the reader
using the USB Type C connector. The
PCR91501 Reader has on board LEDs to
display status of the reader and tag devices.
The PCR91501 has a factory set, fixed power
output of 3W EIRP.
ORDERING OPTIONS
United States Part
Number
PCR91501
Canada Part Number
PCR91501-CA
PRODUCT CONTENTS
The following items are included:
Qty
Description
1
PCR91501 Transmitter
1
Cable
1
Quick start instruction card
APPLICATIONS
• Communicate with and power high
function RFID tags
o Active, battery recharging tags
o Passive, charge-and-fire tags
• Communicate with and charge
consumer electronic devices
o Headphones, earbuds, game
controllers, remotes, keyboards and
mice, etc.
• Communicate with and power sensor
devices
o Temperature, pressure, humidity,
etc.
• Inventory items in a room
User Manual
PCR91501 – Powercast RFID Reader
Rev 1.4 – 2022/09 User’s Manual – PCR91501 RFID Reader Page 2
www.powercastco.com
SET-UP AND OPERATION
1. Place the Reader in the desired location.
2. Plug in the USB-C cable to the back of the reader.
3. Connect the other end to a 5V USB A device. The Reader’s LED will illuminate and the
PCR91501 will start polling for end for devices.
4. Data is provided on the USB-A connector.
5. The PCR91501 will automatically turn off if no tag devices are present. It will
periodically poll for the presence of tag devices.
The status LED indicates the following operating conditions:
LED
Status
Description
Off
Off
Device is not Powered
Solid Green
Active
Device has power
Solid Blue
Data Received
Tag device is present
CAPTURING DATA FROM THE READER
1. Connect the RFID Reader to a PC or other communication device using the USB-A to
USB-C cable.
2. Open USB Serial Port connection, such as Tera Term
3. Use the following settings:
a. Speed: 9600
b. Data: 8 bit
c. Parity: Even
d. Stop bits: 1 bit
e. Flow control: none
4. The reader will automatically start sending reader and tag data to the PC or
communication device.
User Manual
PCR91501 – Powercast RFID Reader
Rev 1.4 – 2022/09 User’s Manual – PCR91501 RFID Reader Page 3
www.powercastco.com
SPECIFICATIONS
Item
Frequency
RF Communication
Power output
Beam pattern
Approvals
Interface
Operating
Temperature
Environment
Mounting
Power
Color
Dimensions
Note: The PCR91501 is not EPC Gen 2 Compliant
User Manual
PCR91501 – Powercast RFID Reader
Rev 1.4 – 2022/09 User’s Manual – PCR91501 RFID Reader Page 4
www.powercastco.com
SUPPORT
Technical support for Powercast products can be initiated through the following methods:
Website contact form: http://www.powercastco.com/contact/
Telephone: +1 412-455-5800
COMPLIANCE STATEMENTS
Changes or modifications not expressly approved by Powercast could void the user’s authority
to operate the equipment. Use and maintain device only as specified in this manual.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
User Manual
PCR91501 – Powercast RFID Reader
Rev 1.4 – 2022/09 User’s Manual – PCR91501 RFID Reader Page 5
www.powercastco.com
WARNING!
FCC Radiation Exposure Statement:
This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled
environment under the following conditions:
1. This equipment should be installed and operated such that a minimum separation distance of
20cm is maintained between the radiator (antenna) & user’s/nearby person’s body at all times.
2. This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
IC Radiation Exposure Statement:
This equipment complies with IC’s RF radiation exposure limits set forth for an uncontrolled
environment under the following conditions:
1. This equipment should be installed and operated such that a minimum separation distance of
30cm is maintained between the radiator (antenna) & user’s/nearby person’s body at all times.
2. This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
1. Cet équipement doit être installé et utilisé de manière à ce qu'une distance de séparation minimale
de 30 cm soit maintenue à tout moment entre le radiateur (antenne) et le corps de l'utilisateur / de la
personne proche. 2. Cet émetteur ne doit pas être situé à proximité ou fonctionner en conjonction avec
toute autre antenne ou émetteur.
User Manual
PCR91501 – Powercast RFID Reader
Rev 1.4 – 2022/09 User’s Manual – PCR91501 RFID Reader Page 6
www.powercastco.com
IMPORTANT NOTICE
Information furnished by Powercast Corporation (Powercast) is believed to be accurate and
reliable. No license, express or implied, to any intellectual property rights is granted by this
document. No responsibility is assumed by Powercast for its use, nor for any infringements of
patents or other rights of third parties that may result from its use. Powercast assumes no
liability for misuse of this product. Specifications are subject to change without notice.
No license is granted by implication or otherwise under any patent or patent rights of
Powercast. Trademarks and registered trademarks are the property of their respective owners.
Powercast’s standard Terms and Conditions and Limited Product Warranty are available at:
https://www.powercastco.com/terms-conditions/
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Powercast PCR91501 Manuel utilisateur

PCR91501
Marque
Powercast
Modèle
PCR91501
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents