Bauknecht DNHV 3460 SG Program Chart

Taper
Program Chart
DNV 3360 - DNI 3360
DNHI 3460 - DNHV 3460
5019 100 75016
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 43 cm (Elektroplatten), 65 cm (Gas-, Öl- oder
Kohlekochplatten)
INSTALLATION SHEET
Minimum height above cooker: 43 cm (electric cookers), 65 cm (gas, gasoil or
coal cookers)
FICHE D'INSTALLATION
Distance minimale par rapport à la cuisinière : 43 cm (cuisinière électrique), 65 cm
(cuisinière à gaz, à mazout ou à charbon)
INSTALLATIESCHEMA
Min. afstand van het kooktoestel: 43 cm (elektrische kooktoestellen) 65 cm
(kooktoestellen op gas, olie of kolen)
FICHA DE INSTALACIÓN
Distancia mínima desde los quemadores: 43 cm (quemadores eléctricos), 65 cm
(quemadores a gas, gasóleo o carbón)
FICHA DE INSTALAÇÃO
Distância mínima do fogão: 43 cm. (fogões eléctricos), 65 cm. (fogões a gás, óleo ou carbono)
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 43 cm (fuochi elettrici), 65 cm (fuochi a gas, gasolio o carbone)
ùüùü+ùùùþ
ü$12.)12.1.)2"0120"FP02!"0120"FP0120".0 ! #
02!0. #0! #.
D
GB
F
NL
E
P
I
*5
CLOSED
OPEN
CLOSED
OPEN
1
2
22
3
3
Ø 2,5mm x
6mm max
4
5
6
7
7
6mm
7
8
9
10
11
DNV 3360 - DNI 3360
DNHI 3460 - DNHV 3460
5019 100 75016
AA
A
FF
F
12
14
Ø
135mm
16
15
17
10x10mm
13
25
23
23
22
22
20
19
21
20mm
16mm
CLOSED
OPEN
CLOSED
OPEN
25
24
24 24
OK!OK!
OK!
18
DNV 3360 - DNI 3360
DNHI 3460 - DNHV 3460
5019 100 75016
1.
Control panel
2.
Grease filter (inside the extractor grille)
3.
Lighting unit
4.
Pull-out steam deflector
RENEWING BULBS
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam drawer.
3.
Open the rear extractor grille.
4.
Remove the burnt-out bulb and insert a
new one.
Use only 40W max (E14) bulbs.
5.
Remount the extractor grille.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam drawer.
3.
Remove the extractor grille.
4.
Release the grease filter.
5.
Remove the dirty grease filter.
6.
After renewing or cleaning the grease filter
(depending on model) repeat the above
steps in reverse to reassemble, making sure
the entire extraction surface is covered.
MOUNTING OR RENEWING THE
CARBON FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam drawer.
3.
Remove the extractor grille.
4.
If a carbon filter is already mounted and
needs renewing, press the release buttons
(b) and pull the filter out downwards.
5.
If the filters are not mounted.
a.
fit the carbon filter into the upper clips.
b.
fasten using the lower clips.
6.
Remount the extractor grille.
CONTROL PANEL
A.
Light switch.
B.
Speed selector.
C.
Intensive extraction (only for models
DNHI 3460
and
DNHV 3460
).
1
4
2
3
0123
0I
aa
bb
CLOSED
OPEN
CLOSED
OPEN
25
24
24 24
C
A
B
small amount of steam and fumes
large amount of
steam and fumes
medium amount of steam and fumes
PRODUCT DESCRIPTION SHEET
F NL E PGBD GRI
  • Page 1 1
  • Page 2 2
  • Page 3 3

Bauknecht DNHV 3460 SG Program Chart

Taper
Program Chart

dans d''autres langues