REOLINK RLC-523WA Mode d'emploi

RLC-523WA
REOLINK
Marque
REOLINK
Modèle
RLC-523WA
Catégorie
Des caméras de sécurité
Taper
Mode d'emploi
RLC-523WA
Quick Start Guide
@ReolinkTech https://reolink.com
January 2021
QSG1_A_EN
58.03.001.0177
2English
1 English
Contents What’s in the Box
EN
What's in the Box
Camera Introduction
Connection Diagram
Set up the Camera
Mount the Camera
Troubleshooting
Specifications
Notification of Compliance
2
3
4
5
6
9
10
11
1m
Ethernet Cable
Antennas *
4.5m Power
Extension Cable *
Waterproof Lid
Quick
Start Guide
Surveillance
Sign
Mounting
Template
Pack
of Screws
Camera
Power
Adapter
4English
3 English
Connection Diagram
Before initial setup, follow the steps below to connect your camera.
1. Connect the camera to a LAN port on your router with an Ethernet cable.
2. Use the power adapter provided to power on the camera.
Camera Introduction
Power Adapter
Router
PTZ Camera
Power Cable
Network Cable
Network Cable
Power Port(Optional)
Earth Wire
Reset Button
*Press and hold for 10seconds to restore camera to
factory settings.
Lens
Built-in Mic
Antenna
Speaker
SD Card Slot
Metal Aluminum Case
Daylight Sensor
Spotlight
Infrared Lights
6English
5 English
Download and launch the Reolink App or Client software and follow the
onscreen instructions to finish initial setup.
Set up the Camera
Installation Tips
• Do not face the camera towards any light sources.
• Do not point the camera towards a glass window. Or, it may result in
poor image performance due to the window glare from infrared LEDs,
ambient lights or status lights.
• Do not place the camera in a shaded area and point it towards a well-lit
area. Or, it may result in poor image performance. For better image
quality, please make sure that the lighting condition for both the camera
and the captured object is the same.
• For better image quality, it’s recommended that the lens be cleaned
with a soft cloth regularly.
• Make sure the power ports are not exposed to water or moisture or
blocked by dirt or other elements.
• Do not install the camera in places where rain and snow may hit the
lens directly.
• The camera may work in extremely cold conditions as low as -25°C as it
will produce heat when powering on. You may power on the camera
indoors for a few minutes before installing it outdoors.
Mount the Camera
• On Smartphone
• On PC
Scan to download the Reolink App.
Download path of the Reolink Client: Go to https://reolink.com > Support
> App & Client.
Available on the
NOTE:
• If you are connecting the PoE camera to a Reolink PoE NVR, please set
up the camera via the NVR interface.
• If you are setting up a WiFi PTZ camera, you need to follow the
onscreen instructions to finish the WiFi configuration first.
1
2
3
Mount the Camera to the Wall
8English7 English
Drill holes in accordance with the
mounting hole template.
To adjust the camera direction, you may control the
camera to pan and tilt via Reolink App or Client.
NOTE: Use the drywall anchors
included in the package if needed.
Install the mount base with screws
included in the package.
NOTE: Run the cable through the
cable notch on the mount base. As
for the WiFi camera, it is
recommended that the antennas
be installed upward or horizontally
for better WiFi connection.
PTZ
Operating Temperature: -10°C to 55°C (14°F to 131°F)
Operating Humidity: 10%-90%
Weather Resistance: IP66 certified weatherproof
Specifications
Night Vision: Up to 60 meters (190ft)
Day/Night Mode: Auto switchover
Angle of View: Horizontal: 96°~27°, Vertical: 69°~21°
Pan&Tilt Range: Pan: 360° Tilt: 0°~90°
Hardware Features
General
Troubleshooting
Camera Is Not Powering on
If your camera is not powering on, please try the following solutions:
Pan&Tilt Is Not Working
If the pan&tilt is not working , please try the following solutions:
• Power cycle the camera and see if it will automatically pan/tilt. If not,
the camera may be faulty. If yes, please refer to the further steps.
• If the camera fails to pan/tilt via Reolink App/Client on the
WAN(remotely), try it on the LAN(locally) and see if it works.
• Upgrade the Reolink App/Client and the camera firmware to the latest
version.
• Restore the camera to factory settings and check the pan/tilt again.
If these won’t work, contact Reolink Support https://support.reolink.com
For WiFi Camera
• Camera only supports one power extension cable, do not use two
extension cables.
• Plug the camera into a dierent outlet and see if it works.
• Power on the camera with another working 12V 2A DC adapter and see
if it works.
If these won’t work, contact Reolink Support https://support.reolink.com
10English
9 English
Size: Φ136 x 201mm
Weight: 1.8kg
For more specifications, visit https://reolink.com
Notification of Compliance
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including
interference that may cause undesired operation.
Reolink declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal,
Simplified EU Declaration of Conformity
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment shall be installed and
operated with minimum distance 20cm between the radiator & body.
FCC RF Exposure Warning Statements
Correct Disposal of This Product
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more
12English
11 English
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmentally safe
recycling.
By using the Product Software that is embedded on the Reolink product,
you agree to the terms of this End User License Agreement (“EULA”)
between you and Reolink. Learn more: https://reolink.com/eula/.
End User License Agreement
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d' en compromettre le fonctionnement.
ISED Statements
The device has been evaluated to meet general RF exposure
requirements. The device can be used in mobile exposure conditions.
The min separation distance is 20cm.
Déclaration d'exposition aux radiofréquences pour IC L'appareil a été
évalué pour répondre aux exigences générales en matière d'exposition
aux RF. L'appareil peut être utilisé dans des conditions d'exposition
mobiles. La distance de séparation minimale est de 20cm.
Radio Frequency Exposure Statement for IC
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal,
This product comes with a 2-year limited warranty that is valid only if
purchased from Reolink ocial stores or a Reolink authorized reseller.
Learn more: https://reolink.com/warranty-and-return/.
Limited Warranty
Use of the product is subject to your agreement to the Terms of Service
and Privacy Policy at reolink.com. Keep out of reach of children.
Terms and Privacy
NOTE: We hope that you enjoy the new purchase. But if you are not
satisfied with the product and plan to return, we strongly suggest that
you reset the camera to factory default settings and take out the
inserted SD card before returning.
recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmentally safe
recycling.
13 English 14English
15 English
Operation of this device is restricted to indoor use only. (5180-5240MHz)
Le fonctionnement de cet appareil est limité à une utilisation en intérieur
uniquement. (5180-5240MHz)
OPERATING FREQUENCY (For WiFi Version)
2412MHz---2462MHz
5150MHz---5250MHz
5725MHz---5825MHz
Technical Support
If you need any technical help, please visit our ocial support site and
contact our support team before returning the products:
https://support.reolink.com
This radio transmitter IC: 26839-2201F has been approved by
Innovation, Science and Economic Development Canada to operate with
the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater
than the maximum gain indicated for any type listed are strictly
prohibited for use with this device.
Cet émetteur radio IC : 26839-2201F a été approuvé par Innovation,
Sciences et Développement économique Canada pour fonctionner avec
les types d'antenne énumérés ci-dessous, avec le gain maximal
admissible indiqué. Les types d'antenne non inclus dans cette liste qui
ont un gain supérieur au gain maximum indiqué pour tout type
répertorié sont strictement interdits pour une utilisation avec cet
appareil.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

REOLINK RLC-523WA Mode d'emploi

RLC-523WA
REOLINK
Marque
REOLINK
Modèle
RLC-523WA
Catégorie
Des caméras de sécurité
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents