AM-USB-WF/AM-USB-WF-I
AirMedia® USB Adapter with Wi-Fi® Connectivity
Product Information - 8630A
(2055193)
03.20
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/8494
For additional information on the AM-USB-WF,
visit www.crestron.com/model/6511400.
For additional information on the AM-USB-WF-I,
visit www.crestron.com/model/6511401.
Certification and Compliance
Regulatory Model: 5B06
FCC ID: 2AKC6XHT-WF5E
IMPORTANT NOTE: To comply with ISED CANADA
and FCC RF exposure compliance requirements,
the antenna used for this transmitter must be
installed to provide a separation distance of at
least 20 cm from all persons and must not be co-
located or operating in conjunction with any other
antenna or transmitter.
REMARQUE IMPORTANTE: Pour être conforme aux
exigences de conformité d’ISED CANADA et de la
FCC en matière d’exposition aux radiofréquences,
l’antenne utilisée pour cet émetteur doit être
installée de manière à assurer une distance de
séparation d’au moins 20 cm de toutes les
personnes. toute autre antenne ou émetteur.
Federal Communications Commission (FCC)
Compliance Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment
and receiver.
l Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Crestron Electronics, Inc.
15 Volvo Drive, Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: 201.767.7656
www.crestron.com
Product Information - Doc. 8630A
(2055193)
03/31/20
l Consult the dealer or an experienced radio/TV
technician for help.
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
ISED Canada
This device contains licence-exempt transmitter
(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the
following two conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement
économique Canada applicables aux appareils
radio exempts de licence.
L’exploitation est autorisée aux deux conditions
suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accep
As of the date of manufacture, the product has
been tested and found to comply with
specifications for CE marking.
Legal
The product warranty can be found at
www.crestron.com/warranty.
The specific patents that cover Crestron products
are listed at www.crestron.com/legal/patents.
Certain Crestron products contain open source
software. For specific information, visit
www.crestron.com/opensource.
Crestron and the Crestron logo are either
trademarks or registered trademarks of Crestron
Electronics, Inc. in the United States and/or other
countries. Wi-Fi is either a trademark or registered
trademark of Wi-Fi Alliance. Other trademarks,
registered trademarks, and trade names may be
used in this document to refer to either the entities
claiming the marks and names or their products.
Crestron disclaims any proprietary interest in the
marks and names of others. Crestron is not
responsible for errors in typography or
photography.
©2020 Crestron Electronics, Inc.
-
1
-
2
