Leap Frog ABC Phonics Word Builder Mode d'emploi

Marque: Leap Frog

Modèle: ABC Phonics Word Builder

Catégorie: Jouets d'apprentissage

Taper: Mode d'emploi

Ce manuel convient également à

80-611100 ABC Phonics Word Builder

91-003842-000

Parent’s Guide

This guide contains important information. Please keep it for future reference.

INTRODUCTION

Thank you for purchasing the ABC Phonics Word Builder

Learn letters and their sounds and blend those sounds into words with

this fun and interactive device. Play six learning games to explore 250+

words, letter sounds and spelling. Use the three activity cards to practice

vowel letters and consonant letters.

Power Button

Letter Select

Button

Activity Mode

Buttons

Sound Slider

Star Button

Contrast Button Volume Button

Handle

Activity Cards

INCLUDED IN THIS PACKAGE

• ABC Phonics Word Builder

• 3 Double-sided Activity Cards

• Parent’s guide

WARNING

All packing materials such as tape, plastic sheets, packaging

locks, removable tags, cable ties and packaging screws are not

part of this toy and should be discarded for your child’s safety.

NOTE

Please keep this parent’s guide as it contains important

information.

ATTENTION

Pour la sécurité de votre enfant, débarrassez-vous de tous

les produits d’emballage tels que rubans adhésifs, feuilles de

plastique, attaches, étiquettes et vis d’emballage. Ils ne font

pas partie du jouet.

NOTE

Il est conseillé de conserver ce guide des parents car il comporte

des informations importantes.

Rotate the packaging locks 90 degrees

counterclockwise.

Pull out the packaging locks and discard.

Unlock the Packaging Locks

GETTING STARTED

BATTERY REMOVAL AND INSTALLATION

1. Make sure the unit is turned Off.

2. Locate the battery cover located on the back of the unit and

use a screwdriver or coin to loosen the screw and open the

battery cover.

3. Remove old batteries by pulling up on one end of each battery.

4. Install 2 new AA (AM-3/LR6) batteries following the diagram

inside the battery box.

5. Replace the battery cover and tighten the screw to secure.

BATTERY NOTICE

• Use new alkaline batteries for maximum performance.

• Use only batteries of the same or equivalent type as

recommended.

• Do not mix different types of batteries: alkaline, standard

(carbon-zinc) or rechargeable, or new and used batteries.

• Do not use damaged batteries.

• Insert batteries with the correct polarity ( + and - ).

• Do not short-circuit the battery terminals.

• Remove exhausted batteries from the toy.

• Remove batteries during long periods of non-use.

• Do not dispose of batteries in fire.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the toy before charging

(if removable).

• Rechargeable batteries are only to be charged under adult

supervision.

MISE EN GARDE

• Utiliser des piles alcalines neuves pour des performances

maximales.

• Seules des piles du type recommandé doivent être utilisées.

• Ne pas mélanger différents types de piles ou d’accumulateurs,

ne pas mélanger des piles ou des accumulateurs neufs avec

des usagés.

• Ne pas utiliser des piles ou des accumulateurs endommagés.

• Mettre en place les piles ou les accumulateurs en respectant

les polarités + et –.

• Ne pas mettre les bornes d’une pile ou d’un accumulateur

en court-circuit (en reliant directement le + et le –).

• Enlever les piles ou les accumulateurs usagés du jouet.

• Retirer les piles ou les accumulateurs en cas de non-utilisation

prolongée.

• Ne les jeter ni au feu ni dans la nature.

• Ne pas tenter de recharger des piles non rechargeables.

• Enlever les accumulateurs du jouet pour les recharger.

• Les accumulateurs ne doivent être chargés que sous la

surveillance d’un adulte.

PRODUCT FEATURES

1. Power Button

Press the Power Button to turn the toy on

and put the toy to sleep.

2. Sound Slider

Move the Sound Slider left or right to

interact with the objects on the screen.

3. Star Button

Press the Star Button to select letters and

interact with the objects on the screen.

4. Contrast Button

Press the Contrast Button to access the

contrast adjustment screen. Then,

• Move the Sound Slider left or right to

adjust the contrast setting.

• Press the Star Button to confirm the

contrast setting and exit the screen.

5. Volume Button

Press the Volume Button to access the

volume adjustment screen. Then,

• Move the Sound Slider left or right to

adjust the volume setting.

• Press the Star Button to confirm the

volume setting and exit the screen.

6. Letter Select Button

Press the Letter Select Button to access

the letter select screen. Then,

• Move the Sound Slider left or right to

scroll through the alphabet.

• Press the Star Button to select a

letter and play different activities

associated with that letter.

7. Activity Mode Buttons

Press any of the Activity Mode Buttons

to play one of six different learning

activities.

• Letters & Sounds

• Flash Cards

• Sound Blender

• Word Guess

• Letter Bounce

• Spot the Difference

8. Handle

The Handle can be used to carry the

device and to store the three Activity

Cards.

• To store the Activity Cards, detach

the Handle from the back of the

device.

• Slide the Handle through the loops

on the Activity Cards.

• Reattach the Handle to the back of the device.

9. Activity Cards

The three double-sided Activity Cards

can be inserted into the device to

instantly access specific learning

activities.

• Aa – Vowel letter A curriculum

• Ee – Vowel letter E curriculum

• Ii – Vowel letter I curriculum

• Oo – Vowel letter O curriculum

• Uu – Vowel letter U curriculum

• XYZ – Consonant letters curriculum

Remove the Activity Card from the device to access the

Power Button, the Letter Select Button, and the six Activity

Mode Buttons.

10. Automatic Shut-Off

To preserve battery life, ABC Phonics Word Builder

will

automatically shut off after approximately 45 seconds to

one minute without input. To turn the unit on again, press

the Power Button, insert an Activity Card into the device,

or remove an Activity Card from the device.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions,

please follow these steps:

1. Press the Power Button to put the toy to sleep.

2. Interrupt the power supply by removing the batteries.

3. Let the unit stand for a few minutes, then replace the batteries.

4. Turn the unit back On. The unit should now be ready to use

again.

5. If the unit still does not work, install a new set of batteries.

NOTE

If the unit powers down or the low battery image appears,

please install a new set of batteries.

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.

2. Keep the unit out of direct sunlight and away from direct

heat sources.

3. Remove the batteries if the unit will not be in use for an

extended period of time.

4. Do not drop the unit on hard surfaces and do not expose

the unit to moisture or water.

Impact de l’environnement

Une défaillance de fonctionnement de l’appareil peut

survenir s’il est sujet à des interférences avec les fréquences

radioélectriques. Le fonctionnement normal de l’appareil devrait

reprendre avec l’arrêt des interférences. Si ce n’est pas le cas, il

peut s’avérer nécessaire d’éteindre et rallumer l’appareil ou de

retirer et réinstaller les piles. Dans l’éventualité peu probable

d’une décharge électrostatique, un mauvais fonctionnement

et une perte de mémoire de l’appareil peuvent se produire.

L’utilisateur doit alors retirer et réinstaller les piles pour

réinitialiser l’appareil.

IMPORTANT NOTE

If the problem persists, please call our Consumer Services

Department at 1-800-701-5327 in the U.S. or email support@

leapfrog.com. Creating and developing LeapFrog

products

is accompanied by a responsibility that we take very

seriously. We make every effort to ensure the accuracy of the

information, which forms the value of our products. However,

errors sometimes can occur. It is important for you to know

that we stand behind our products and encourage you to

have. A service representative will be happy to help you.

Environmental phenomena

The unit may malfunction if subjected to radio-frequency

interference. It should revert to normal operation when the

interference stops. If not, it may become necessary to turn the

power OFF and back ON, or remove and reinstall the batteries.

In the unlikely event of an electrostatic discharge, the unit may

malfunction and lose memory, requiring the user to reset the

device by removing and reinstalling the batteries.

CAUTION

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to

operate the equipment.

NOTE

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician

for help

Supplier’s Declaration of Conformity

47 CFR § 2.1077 Compliance Information

Trade Name: LeapFrog

Model: 6111

Product Name: ABC Phonics Word Builder

Responsible Party: LeapFrog Enterprises, Inc.

Address: 6401 Hollis Street, Suite 100

Emeryville, CA 94608

Website: leapfrog.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.

OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:

(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,

AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE

RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE

UNDESIRED OPERATION.

CAN ICES-3 (B)/NMB-3(B)

91-003842-000

Visit our website for more

information about our products,

downloads, resources and more.

leapfrog.com

Read our complete warranty policy online at

leapfrog.com/warranty.

LeapFrog Enterprises, Inc.

A subsidiary of VTech Holdings Limited.

Printed in China.

Leap Frog ABC Phonics Word Builder Mode d'emploi

Marque: Leap Frog

Modèle: ABC Phonics Word Builder

Catégorie: Jouets d'apprentissage

Taper: Mode d'emploi

Ce manuel convient également à

80-611100 ABC Phonics Word Builder

Télécharger le PDF

rapport

dans d''autres langues

English: Leap Frog ABC Phonics Word Builder User guide

Leap Frog ABC Phonics Word Builder Mode d'emploi

Ce manuel convient également à

Leap Frog ABC Phonics Word Builder Mode d'emploi

dans d''autres langues

Autres documents