Ohaus OHA-30134157 Le manuel du propriétaire

Frontier

TM

Centrifuge FC5306

Instruction Manual

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

TABLE OF CONTENTS

1. INTRODUCTION ....................................................................................... 1

1.1 Safety measures ............................................................................... 1

2. INSTALLATION ......................................................................................... 3

2.1 Package contents .............................................................................. 3

2.2 Replacement or Installation of Rotor ................................................. 4

2.3 Power On .......................................................................................... 5

1.4 Preparation for Centrifugation ........................................................... 5

2.5 Centrifugation (Running) ................................................................... 5

3. SPECIAL ATTENTION .............................................................................. 6

3.1 Power supply ..................................................................................... 6

3.2 Use and maintenance ....................................................................... 6

4. SPECIFICATIONS .................................................................................... 7

5. COMPLIANCE ........................................................................................... 8

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

Frontier

TM

FC5306 EN-1

1. INTRODUCTION

Thank you for choosing this OHAUS product.

Please read the manual completely before using the Frontier

TM

FC5306 to

avoid incorrect operation.

You will find much helpful functionality in Frontier

TM

5000 series centrifuge. A

few of the many existing features for Frontier

TM

FC5306 are:

 Small and exquisite body, one-key operation

 Convenient and quick installation and replacement of rotor without need of

using tool

 Rotor will immediately stop running if lid is opened during operation

 Desktop power adapter is applicable to 100-240V AC power supply

Elaborate product with low noise and long service time

1.1 Safety measures

CAUTION: Read all safety warnings before installing, making

connections, or servicing this equipment. Failure to comply with

these warnings could result in personal injury and/or property

damage. Retain all instructions for future reference.

Measures for your protection

 Never work in an environment subject to explosion hazards!

The housing of the instru¬ment is not gas tight. (explosion

hazard due to spark formation, corrosion caused by the ingress

of gases)

 When using chemicals and solvents, comply with the

instructions of the producer and the general lab safety rules.

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

EN-2 Frontier

TM

FC5306

Measures for operational safety

 Do not lean on the centrifuge.

 Do not stay within the clearance envelope longer than necessary for

operational reasons.

 Do not deposit any potentially hazardous materials within the clearance

envelope.

 Do not unscrew the two halves of the housing.

 Dry off any liquid spills immediately! The instrument is not watertight.

 Verify that the AC adapter’s input voltage range and plug type are

compatible with the local AC power to be used.

 Do not position the equipment such that it is difficult to disconnect the AC

adapter from the power receptacle.

 Make sure that the power cord does not pose a potential obstacle or

tripping hazard.

 The equipment is for indoor use only. Use the equipment only in dry

locations.

 Use only approved accessories and peripherals.

 Operate the equipment only under ambient conditions specified in these

instructions.

 Disconnect the equipment from the power supply when cleaning.

 Do not operate the equipment in hazardous or unstable environments.

 Service should only be performed by authorized personnel.

Exclude the following environmental influences:

 Powerful vibrations

 Direct sunlight

 Atmospheric humidity greater than 80%

 Corrosive gases present

 Temperatures below 5 °C and above 40 °C

 Powerful electric or magnetic fields

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

Frontier

TM

FC5306 EN-3

2. INSTALLATION

Carefully unpack the box.

2.1 Package contents

The model Frontier

TM

FC5306 has the following items:

Frontier

TM

FC5306

Photo

Units

Frontier

TM

FC5306 main

machine

1 set

Angle rotor ( 8 x 1,5/2ml)

1 set

4 x 0.2ml rectangle rotor for

PCR 8-tube bank

1 set

Dedicated DC24V power

adapter

1 set

Eight 0.5 ml adapters and

eight 0.2 ml adapters

8 x 2 units

Manual

1 set

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

EN-4 Frontier

TM

FC5306

2.2 Replacement or Installation of Rotor

1. When the machine is delivered from the factory, the seizing shaft sleeve

and angle rotor are firmly fixed on the shaft of the drive motor.

2. If it is necessary to dismantle an installed rotor, the user should hold the

outside edge of the rotor, and push the protruding clamp towards its

center with two thumbs, then lift the rotor upwards.

3. To reinstall rotor, align the oval hole of rotor over the clamp, then gently

press down the rotor until the clamp clicks into place.

角转头

电机轴套

Angle Rotor

Motor Shaft Sleeve

Clamp

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

Frontier

TM

FC5306 EN-5

2.3 Power On

1. With the power switch on the back of this machine OFF.

2. Connect the output end of the adapter to the power socket on the back of

the machine, and then plug the unit to a power source.

1.4 Preparation for Centrifugation

1. Open the transparent lid (see photo below) and properly add load in a

balanced manner (refer to section “3.2 use and maintenance”).

2. Close the lid then press the power switch on the back of this machine to

ON (note: The rotor will not run as long as the lid is open).

2.5 Centrifugation (Running)

1. After the lid is closed and the machine switched on, the rotor will

automatically start running with its speed increasing to the rated speed,

and then it will run stably.

2. Open the lid when the requirement of centrifugation is met, the rotor will

immediately slow down to a complete stop.

3. It is unnecessary to turn off power if another centrifugation is required.

4. Turn off and unplug the machine when all centrifugation work is completed

or when not in use.

press down to

open the lid

offenen Deckel

n Sie den

offenen Deckel

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

EN-6 Frontier

TM

FC5306

3. SPECIAL ATTENTION

3.1 Power supply

1. The power supply to this machine must be realized through the adapter

provided together with the machine. The AC plug of adapter should not be

connected with three-phase power source.

2. Don’t insert or disconnect the power plug of the adapter with wet hand.

Don’t forcibly pull the cable to disconnect the power plug.

3.2 Use and maintenance

1. Prepare the micro burette of standard specification with hinged cover for

centrifugation. It is only allowed to add sample till approx. 70% of nominal

capacity at most. Visually check balance during adding of sample. Don’t

detach any poisonous or infectious biological sample. Don’t detach

flammable or explosive chemical sample.

2. The centrifugal tubes with sample must be symmetrically placed into the

centrifugal tube holes of the rotor to keep the rotor balanced.

3. When the rotor is installed or replaced, excessive sidewise force should

be avoided to prevent its deformation and bending. If the seizing shaft

sleeve around the motor shaft is a bit loose, it is necessary to fasten the

M3 set screw again.

4. Do not use broken or deformed rotor.

5. During daily cleaning and maintenance, the machine should be wiped with

clean water or neutral detergent, and be dried through natural ventilation.

6. During use, attention should be paid to symmetrical and horizontal

placement of centrifugal tubes.

WARNING: Disconnect the AC adapter from the AC power

supply and the equipment before cleaning. Do not allow liquids

to enter the AC adapter or the equipment.

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

Frontier

TM

FC5306 EN-7

4. SPECIFICATIONS

The technical data is valid under the following ambient conditions:

Operating temperature: 5°C to 40°C

Relative humidity: 20% to 85% relative humidity, non-condensing

Height above sea level: Up to 2000 m

Pollution degree: 2

Installation category: II

Main supply voltage fluctuations: up to ± 10% of the nominal voltage

Model

Frontier Mini Centrifuge：FC5306

Rotor

Angle Rotor

Tube Bank Rotor

Rotating Speed Scope

6000 rpm ± 5%

Centrifugal Force

2000 g ± 10%

Rotating Direction

Counter clockwise

Max Capacity

8 x 1.5 ml / 2 ml

4 x 0.2 ml-PCR 8-tube

bank

or 32 x 0.2 ml single

centrifugal tube

Adapter

0.2 ml / 0.5 ml

-

Accelerating Time

≤2 s

Decelerating Time

≤3 s

Drive Mode and Motor

Direct drive, with low noise attributable to rolling bearing

Power Supply

Input: 100-240V ~ 50/60Hz 1.5A

Output: 24V 2.0A

Dimensions (W × D × H)

5.9 × 6.6 × 5.0 in. / 150 × 168 × 128 mm

Net Weight

2.316 lb / 1.05 Kg (including free-load angle rotor)

Shipping Dimensions

(W × D × H)

8.5 × 12.0 × 7.6 in. / 216 × 305 × 194 mm

Shipping Weight

4.079 lb / 1.85 Kg

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

EN-8 Frontier

TM

FC5306

5. COMPLIANCE

Compliance to the following standards is indicated by the corresponding mark

on the product.

Marking

Standard

This product conforms to the EMC directive 2014/30/EU and the

Low Voltage Directive 2014/35/EU. The complete Declaration of

Conformity is available online at

www.ohaus.com/ce.

Disposal

In conformance with the European Directive 2002/96/EC on

Waste Electrical and Electronic Equipment (WEEE) this device

may not be disposed of in domestic waste. This also applies to

countries outside the EU, per their specific requirements.

Please dispose of this product in accordance with local

regulations at the collecting point specified for electrical and

electronic equipment.

If you have any questions, please contact the responsible

authority or the distributor from which you purchased this

device.

Should this device be passed on to other parties (for private or

professional use), the content of this regulation must also be

related.

For disposal instructions in Europe, refer to

www.ohaus.com/weee.

Thank you for your contribution to environmental protection.

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

Frontier

TM

FC5306 EN-9

FCC Note

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help.

Industry Canada Note

This Class B digital apparatus complies with Canadian ICES-001.

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

Ohaus Corporation

7 Campus Drive

Suite 310

Parsippany, NJ 07054 USA

With offices worldwide / Con oficinas en todo el mundo/ Avec des bureaux

dans le monde entier/ Mit Niederlassungen weltweit/ Con uffici in tutto il

mondo

http://www.ohaus.com

*30129575*

diritti riservati

Printed in China / Impreso en China/ Imprimé en Chine / Gedruckt in China /

Stampato in Cina

(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com

Ohaus OHA-30134157 Le manuel du propriétaire

Ce manuel convient également à

Ohaus OHA-30134157 Le manuel du propriétaire

dans d''autres langues

Documents connexes

Autres documents