Keystone LDTR02 Mode d'emploi

LDTR02
Keystone
Marque
Keystone
Modèle
LDTR02
Taper
Mode d'emploi
OUTOUT
ININ
OUTOUT BUTTONBUTTON
ININ BUTTONBUTTON
STARTSTART BUTTONBUTTON
FCCFCC IDID NUMBERNUMBER LOCATIOLOCATIO
3-6. 3B FEMA LE TERM INAL WI THCOV ER
Φ
8 TER MINAL
CHART2CHART2
CHART1CHART1
ANTENNAANTENNA
OUTOUT WHITEWHITE
ININ WHITEWHITE
POWER+REDPOWER+RED
POWER-BLACKPOWER-BLACK
1.The function instruction of the front plate please see the picture 1
2.Press the power on button for 3 seconds to start the remote, the blue wireless light will be on .
The remote will close if there is no operation within 2mins by itself.Press OUT button ,
the winch will send out the rope (nylon rope /steel wire rope ),
press IN button , the wich will recycle the rope (nylon rope /steel wire rope )
3.Voltage of the sender :DC2-3.0V voltage of the receiver :DC9-15V
4.Distance ≤15M Due to the interference from the actual environment are always change when in use,
So the usage distance of the remote will change (distance is shorter).
5.To learn the matching function, keep pressing the power on button of the sender until the green light flicker,
in the meantime press the learn button on the receiver until the red light on , flicker, and closed with voice "tick",
then it means it's successful to matching the sender.
6.the receiver function please see the picture 2
FCC Statement:
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The
device has been evaluated to meet general RF exposure requirement.
Le matériel est conforme aux limites de dose d'exposition aux rayonnements énoncés pour fac un autre
environnement. ce dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.
  • Page 1 1
  • Page 2 2

Keystone LDTR02 Mode d'emploi

LDTR02
Keystone
Marque
Keystone
Modèle
LDTR02
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Autres documents