LEEDARSON CAG1a100015W7P Manuel utilisateur

Taper
Manuel utilisateur
Model CAG1a100015W7P
Product features:
Controlled by microwave 5.8 G to realize the Motion Detection.
Product Name
LED Luminaire
Brand Name
LEEDARSON
Model No.
CAG1a100015W7P
Work Temperature
-20-40
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
This device comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with FCC radiation exposure limits set forthfor an
uncontrolled environment. This equipment should be installed andoperated with
minimum distance of 20 cm between the radiator and yourbody.
Le rayonnement de la classe b repecte ISED fixaient un environnement non contrôs.
Installation et mise en œuvre de ce matériel devrait avec échangeur distance minimale
entre 20 cm ton corps. Lanceurs ou ne peuvent pas coexister cette antenne ou capteurs
avec d’autres.
luminaires Installation Height: Rated 3 m.
Motion Sensor Detect Range: Rated 3 m.
Motion Sensor Detect Angles: 90° based on 3m. installation height (the detect angle differs
with the different installation height)
Hold-time: Light will keep stay on 30s ±3 after motion stops
When the luminaires powered on, the luminaires will lights on about 10s, then light off, the
motion sensor starts to detect the react it based on the movement around.
  • Page 1 1
  • Page 2 2

LEEDARSON CAG1a100015W7P Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues