• If your laundry is normally or lightly
soiled, it may be advisable to shorten
the washing programme. Touch this
button once to decrease the duration.
• In case of smaller load, touch this
button twice to set an extra quick
programme.
The display shows the indicator .
This option can also be used
to shorten the Steam
programme duration.
7.5 Temp.
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Set this option to change the default
temperature.
The indicator = cold water of the set
temperature comes on (the appliance
does not heat the water).
7.6 Spin
When you set a programme, the
appliance automatically selects the
maximum spin speed. The display shows
only the spin speeds available for the set
programme.
Touch this button repeatedly to:
• Decrease the spin speed.
• Activate the Rinse Hold option .
The water of the last rinse is not
drained out to prevent the fabrics
from creasing. The washing
programme ends with water in the
drum and the final spin phase is not
performed.
The display shows the indicator .
The lid stays locked. The drum turns
regularly to reduce creasing. You
must drain the water to unlock the lid.
Touch Start/Pause button: the
appliance performs the spinning
phase and drains the water.
• Activate the Extra Silent option.
All spinning phases (intermediate spin
and final spin) are suppressed and the
programme ends with water in the
drum. This helps to reduce creasing.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
The display shows the indicator
.
The lid stays locked. The drum turns
regularly to reduce creasing. You
must drain the water to unlock the lid.
Touch the Start/Pause button: the
appliance performs only the draining
phase.
The appliance empties
the water out
automatically after
approximately 18 hours.
• Activate the Only Drain option
(Skipping the wash, rinse and spin
phases) .
The appliance performs the only
draining phase of the selected
washing programme.
The display shows the indicator
(cold), and the indicator (no
spin) and the indicator
.
• Activate the Only Spin option
(Skipping the wash and rinse
phases) .
The appliance performs only the
spinning phase of the selected
washing programme.
The display shows the indicator
(cold), the phase indicator and the
spin speed.
If it is necessary to reduce
the spin speed, select a
programme with a lower
spin speed as default.
7.7 Stain/Prewash
Press this button repeatedly to activate
one of the two options.
• Stain
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment . The stain remover
will be added in the appropriate
phase of the washing programme.
www.aeg.com
14