8
• To remove the shoulder harness, turn the plastic ends sideways and push them through the slots
in the seatback. Reattach the harness at the proper height by reinserting the plastic ends through
the slots. (20) Ensure both straps are the same height.
• To remove the crotch strap, slide the strap through the small opening in the metal D-ring.
Reattach by pushing the metal-D ring through the slot in the seat, wrap the strap around the tube
under the seat bottom. Slide the strap through the small opening of the metal D-Ring and pull the
strap to secure it to the tube. (21)
• Remove the waist straps by sliding the strap through the small opening in the metal D-ring, then
pull the strap away from the seat. (22) Reattach by pushing the metal-D ring through the slot
in the seat, wrap the strap around the seat back frame tube. Slide the strap through the small
opening of the metal D-Ring and pull the strap to secure it to the tube. Repeat for the other end of
the strap.
• To unlatch the buckle press the center button and remove the male ends of each buckle. (23)
• Carefully place the child in the seat with the shoulder straps over their shoulders and chest. Then
place the crotch strap between the child’s legs.
• Push the shoulder/waist latch posts into the crotch buckle until all parts snap into place. (24)
• Tighten the waist belt to be snug around the child’s waist.
• The shoulder, waist, and crotch straps may be adjusted using the sliding plastic rings on these straps.
IWARNING: The front seats are not suitable for a child
under 6 months. Avoid serious injury from falling or sliding out. Always
use the restraint system.
Seat Recline Positioning
The front seat has two positions. This seat should be used for children who are at least 6 months
old. These steps are for BOTH front facing seats.
• To place the seat in the upright position, push the bar on the rear of the seat toward the front of the
stroller and rotate the seatback towards the front of the stroller until this bar is locked in its lowest
position. (25)
• To recline the seat, pull the bar on the rear of the seat toward the rear of the stroller and rotate the
seatback down until this bar is again in its lowest position. (25)
IWARNING: Whether the seatback is upright or reclined,
ALWAYS make certain that the recline mechanism is engaged before
placing the child into the seat.
Using the Stand-On Platform
• Push the bench seat to its most forward position.
• Position the canopy to its most forward position.
• Position the child on the platform on the back of the stroller. Be sure that the child is facing
forward and BOTH of their hands are holding onto the stroller frame.
• Be sure that BOTH of the child’s feet are fully on the platform at all times.
• You may need to adjust the recline position of the seat to allow for more room for the child to stand.
IWARNING: The rear stand-on platform and the rear bench
seat are designed for a child that is at least 2½ years old but LESS
than 44 inches (111.8 cm) tall and less than 45 lbs. (20.5 kg). Use of the
stroller with 3 children totaling more than 125 lbs. (56.8 kg) will cause
excessive wear and stress on the stroller and may cause a hazardous
unstable condition. NEVER allow a standing child to use the canopy as
a hand hold. NEVER use this stroller to carry more than 3 children at the
same time.