Model name:
Ajax HomeSiren
(9NA)
Quick Start Guide
Before using the device, we strongly
recommend reviewing the User Manual
on the website.
Product name: Indoor siren
HomeSiren is a wireless indoor siren with a connector for an
external LED.
Complete Set: 1. HomeSiren; 2. SmartBracket mounting panel;
3. Battery CR123A (pre-installed) – 2 pcs; 4. LED connection clamp;
5. Installation Kit; 6. Quick Start Guide
FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modications not expressly approved by the par ty responsi-
ble for compliance could void the user’s authority to operate the equip-
ment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful in-
terference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
ISED Regulatory Compliance
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the fol-
lowing two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et Dével-
oppement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux condi-
tions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS.
Warranty: Warranty for Ajax devices is valid for two years after the
purchase date and does not apply to the supplied battery. If the
device does not work correctly, you should rst contact the sup-
port service—in half of the cases, technical issues can be solved
remotely!
The full text of the warranty is available on the website:
ajax.systems/warranty
User Agreement: ajax.systems/end-user-agreement
Manufacturer: “AS Manufacturing” LLC.
Address: 5 Sklyarenka Str., Kyiv, 04073, Ukraine.
www.ajax.systems
ajax.systems/
support/devices/
homesiren
Type of notication Acoustic and LED
Sound notication volume 81 – 105 dB at a distance
of 3 ft (adjustable)
Operating frequency
of the buzzer 3.4 ± 0.5 kHz
Tamper protection Yes
Frequency range 905-926,5 MHz FHSS
(complies with part 15 of the FCC rules)
Maximum RF output power 19.77 mW
Radio signal range Up to 6,560 ft (in a line of sight)
Power supply 2 х CR123A battery, 3 V
Battery life Up to 5 years
Socket for connecting
an external light indicator Yes (power supply 3 V, 10 mA)
Operating temperature range 14 - 104 °F
Operating humidity Up to 75%
Dimesions 0.3 х 0.3 x 0.1 ″
Weight 3.42 oz