R03.001_05/06/2015
TECHNICAL FILE
Novopeldaño® Safety Plus
Cleaning and maintenance
Installation
Page 2 of 3
Technical Features and tests
Non-slip strip
(*) Features non-slip strip
The non-slip strip of Novopeldaño® Safety Plus is mafe of aluminum oxide in a 0,1 mm. PVC carrier. It
stands well outdoors, resists motor oil and water and has a certied slip resistance R13 (according to
DIN51130). This non-slip strip is DDA compliant.
Alloy 6063 AA y ASTM
L-3441 UNE 38-301-89
Fire resistance M0 UNE 23-727-90
Abrasion resistance Very good
Lightfastness Excellent
Appearance and color EN 12373-1
Working temperature (*) - 30ºC / +70ºC
Water resistance (*) 10 months
Chemical resistance (*) 8 months
Motor oil resistance(*) Excellent
Longlife 12-24 months (depen-
ding on use)
Sliding resistance (*) R13 DIN51130
1. Spread a big amount of thin-set mortar on the surface of the riser.
2. Place the tile on the riser and press to get an optimal adherence.
3. Then, spread a big amount of thin-set mortar on the tread and align the prole on its vertex so it rests
on the riser (Do not let overhang, the leverage may remove the step and the tiles). Then press so the
thin-set mortar could pass through the mechanized holes of the anchoring wing.
4. Place one tile on the tread, align it to the prole and press to get a perfect adhesion. You can tap it
softly with a rubber hammer.
5. Clean the possible leftover material and let dry.
Novopeldaño® Safety Plus is resistant to detegents and water. The product must be cleaned perio-
dically with a soft cloth. If you use a neutral liquid cleaner, you must rinse the prole with cold water
and dry it to remove the humidity excess. The persistent dirtiness can be removed by using cleaning
approved agents lightly abrasive or a grid covered with polished powder neutral. If a preserving agent
is applied, as well as keep a very thin layer of water repellent, note that it can’t be yellow,attract dust
or dirt or have iridescent effects.
Steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric and
perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommended.
Citric acid is neither recommended because disolves the protective layer of the surface of aluminium.
Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes
(hydrouoroether and chlorinated solvents) and curing accelerators containing chlorides should not be
used (use special accelerators free of chlorides).
-
1
Emac NPSFPAL12GR82 Manuel utilisateur
- Taper
- Manuel utilisateur
- Ce manuel convient également à
dans d''autres langues
- English: Emac NPSFPAL12GR82 User manual
Documents connexes
-
Emac NP413 Guide d'installation
-
Emac NPXK12612 Manuel utilisateur
-
-
-
Emac NPMXTK7812 Guide d'installation
-
-
-
-
-