TYLT Bowl Wireless Charging Pad Manuel utilisateur

Marque
TYLT
Modèle
Bowl Wireless Charging Pad
Taper
Manuel utilisateur
TYLT
Wireless Charger
USER GUIDE
TYLT
Wireless Charger
LIGHT INDICATION
Solid – Charging
Blinking – Error
/ 04/03/20 / 2106_BOW USER GUIDE_R2 / 2
This is a wireless charger that will charge any device that supports the Qi standard, Please read the user manual
before using and keep itfor future reference.
Specifications:
Input: 5V/2A or 9V/1.8A
Wireless Charging Output: 10W (Max.)
Wireless Distance: ≦6mm
Efficiceny: ≧71%
Dimension: 180 x 140 x 60.5 mm
Weight: 70g
Use procedure
1. Connect the device to the adapter with USB cable.
2. Power up the adapter.
3. We can put the mobile phone or iPad right above the device
4. The device is charging
TYLT
BOWL - USER GUIDE
bowl
Wireless Charging Pad
IC3854
LIGHT INDICATION
Solid – Charging
Blinking – Error
/ 04/03/20 / 2106_BOW USER GUIDE_R2 / 2
FCC Statement:
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interfer-
ence, and (2) this device must accept any inte-
rference received, including interference that
may cause undesired operation.
This equipm-ent has been tested and found to
comply with the limits for a Class B digital dev-
ice, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a resi-
dential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipm-
ent and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/
TV technician for help.
Caution: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
This equipment should be installed and
operated with minimum distance 20cm
between the radiator&your body.
IC Statement
This device complies with Industry Canada l
icence-exempt RSS standard(s).
Operation is subject to the following two con-
ditions:
(1) this device may not cause harmful interfe-
rence, and (2) this device must accept anyint-
erference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radioexempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de broui-
llage, et (2)l'utilisateur de l'appareil doit
acceptertout brouillage radioélectrique
subi,même si le brouillage est susceptible
d'en compromettrele fonctionnement.
These designs are representative of
information architecture, indicating priority
and layout of page components.
7KH\GRQRWFRQVWLWXWHWKHƓQDOORRN
or feel of the design.
PREPARED FOR
TYLT
CONTACT
Pawnie Farshi
[email protected]
877-524-2525 Ext. 701
2106_Bow User Guide_r2
04/03/20 / © 2020 Blak Inc. / www.blakinc.com3URSULHWDU\DQG&RQƓGHQWLDO
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

TYLT Bowl Wireless Charging Pad Manuel utilisateur

Marque
TYLT
Modèle
Bowl Wireless Charging Pad
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents