The information provided in this manual is up to date at the time of printing. Any
revisions to this document will supersede the content included. For the latest
applicable version of this manual, visit our website or utilize the QR code.
Wiring
1. GPS recommends the CI-2 be powered constantly and NOT switched with the system or blower.
2. The CI-2 requires a 24VAC or 12-36VDC source. Connect the power wires as follows:
Black = Neutral
Red = Line
Green = Dry Contacts / BAS Alarm
White = Dry Contacts / BAS Alarm
3. Wire in BAS terminals (optional). The CI-2 is equipped with a set of dry contacts that are normally open
and close when the CI-2 is on and has no faults. The contacts are rated up to 125VAC and 300mA.
4. GPS PS-2 (optional). For incoming voltages from 110-277VAC.
Cleaning Cycle
The CI-2 comes with a preset cleaning cycle designed to clean the brushes once every day.
Troubleshooting
1. Unit will not power up, LED not illuminated:
a. Confirm proper voltage is applied to the correct terminal(s).
b. Try disconnecting and re-applying the power source.
2. If the unit does not operate properly after verifying the above instructions please contact GPS for
additional assistance.
Once powered, the unit initiates an internal check of all systems. If the auto cleaning wiper blade is not in
the “home” position, it will move to the home position in series with the airflow.
Operation
CAUTION! Never touch brushes while operating, shock may occur.
ATTENTION: Ne touchez jamais les brosses pendant le fonctionnement, un choc peut se produire.
Product Registration
By registering your order, the standard limited warranty on eligible products from
your purchase is automatically extended to 3 years, at no additional cost.
Register your products at www.gpsair.com/product-registration
or scan the QR code.