Ubiquiti LiteBeam LBE-5AC-LR Guide de démarrage rapide
- Taper
- Guide de démarrage rapide
Antenna Feed
Center Reector Panel
Side Reector Panels (Qty.
2)
Mounting Bracket
Feed Receiver Pivot Panels (Qty. 2) M4 SEM Screws (Qty. 8)
Package Contents
LBE-5AC-LR Quick Start Guide
M8 SEM Screws (Qty. 4) Metal Straps (Qty. 3) Gigabit PoE (24V, 0.3A) with
Mounting Bracket
Power Cord
Installation Requirements
• Phillips screwdriver
• 13 mm wrench
• 7 mm socket wrench or screwdriver
• Shielded Category 5 (or above) cabling with drain wire should be used for
all wired Ethernet connections and should be grounded through the AC
ground of the PoE.
We recommend that you protect your networks from harmful outdoor
environments and destructive ESD events with industrial-grade, shielded
Ethernet cable from Ubiquiti. For more details, visit ui.com/toughcable
• Surge protection should be used for all outdoor installations. We
recommend that you use two Ethernet Surge Protectors, model ETH-SP,
one near the LiteBeam and the other at the entry point to the building. The
ETH-SP will absorb power surges and safely discharge them into the
ground.
LBE-5AC-LR Quick Start Guide
Application Examples
The LiteBeam AC mounted outdoors with the reector installed provides
directional outdoor coverage (gain reector-dependent).
The LiteBeam AC mounted outdoors without the reector installed provides
outdoor-to-indoor coverage using the 3 dBi Antenna Feed only.
Hardware Overview
LBE-5AC-LR Quick Start Guide
Ethernet LED
Power LED
Reset Button
Ethernet Port
The LED will light steady blue when an active Ethernet connection is made
and ash when there is activity.
The LED will light blue when the device is connected to a power source.
To reset to factory defaults, press and hold the Reset button for more than
10 seconds while the LiteBeam AC is powered on. The LiteBeam AC may
also be reset remotely using the auxiliary Reset button located on the
bottom of the Gigabit PoE adapter.
Supports 10/100/1000 connections and passive PoE. This port should be
connected to the LAN and DHCP server.
Hardware Installation
1.
LBE-5AC-LR Quick Start Guide
2.
LBE-5AC-LR Quick Start Guide
3.
LBE-5AC-LR Quick Start Guide
4.
5.
LBE-5AC-LR Quick Start Guide
6.
7.
8.
LBE-5AC-LR Quick Start Guide
9.
10.
LBE-5AC-LR Quick Start Guide
Pole Mounting
1.
2.
LBE-5AC-LR Quick Start Guide
3.
4.
LBE-5AC-LR Quick Start Guide
5.
6.
LBE-5AC-LR Quick Start Guide
Connecting Power
WARNING: The switch port must comply with the power
specications listed in this Quick Start Guide.
OR
Optional
LBE-5AC-LR Quick Start Guide
Accessing airOS via Wi-Fi
Verify connectivity in the airOS® Conguration Interface using the UNMS™
app or Web Portal. Both are available for 15 minutes immediately after you
power on the device. If necessary, you can power cycle the device to re-
enable its Wi-Fi.
UNMS App
1. Download the UNMS app.
2. Connect your device’s Wi-Fi to the SSID named: <model>:<MAC Address>
3. Launch the app and follow the on-screen instructions.
Web Portal
1. Connect your device’s Wi-Fi to the SSID named: <model>:<MAC Address>
2. Launch your web browser and go to: http://setup.ui.com
3. Select your Country and Language. You must agree to the Terms of Use to
use the product. Click Continue.
Note: Ensure that DHCP is enabled on your Wi-Fi adapter.
Note: Ensure that your Wi-Fi connection has DHCP enabled.
LBE-5AC-LR Quick Start Guide
4. Create a username and password. Conrm your new password and then
click Save.
The airOS Conguration Interface will appear, allowing you to customize your
settings as needed. For additional details, refer to the User Guide available at
ui.com/download/airmax-ac
Installer Compliance Responsibility
Devices must be professionally installed and it is the professional installer's
responsibility to make sure the device is operated within local country
regulatory requirements.
LBE-5AC-LR Quick Start Guide
Antenna
Select your antenna from the list. If Calculate EIRP Limit is enabled, transmit
output power is automatically adjusted to comply with the regulations of the
applicable country. For a Custom antenna, Antenna Gain is entered manually.
Note the requirements and antenna types listed below.
Cable Loss (When applicable)
Enter the cable loss in dB. Output power is adjusted to compensate for loss
between the radio and the antenna.
Certied Antenna Types
This radio transmitter FCC ID: SWX-LBE5ACLR / IC: 6545A-LBE5ACLR has been
approved by FCC / ISED Canada to operate with the antenna types listed
below with the maximum permissible gain for each antenna type indicated.
Antenna types not included in this list or having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with this
device.
Antenna Frequency Gain
Grid 5 GHz 26 dBi
Specications
LBE-5AC-LR
Dimensions 512.5 x 385.75 x 258.3 mm
(20.18 x 15.19 x 10.17")
Weight
With Mount 1.360 kg (2.998 lb)
Without Mount 1.735 kg (3.825 lb)
Networking Interface (1) 10/100/1000 Ethernet Port
Antenna Gain 26 dBi
LBE-5AC-LR Quick Start Guide
LBE-5AC-LR
Max. Power Output 25 dBm
Max. Power Consumption 7W
Power Supply 24V, 0.3A Gigabit PoE Adapter
Power Method Passive PoE (Pairs 4, 5+; 7, 8 Return)
Operating Temperature -40 to 70° C
(-40 to 158° F)
Operating Humidity 5 to 95% Noncondensing
ESD/EMP Protection ± 24 kV Contact / Air
Shock and Vibration ETSI300-019-1.4
Wind Survivability 200 km/h (125 mph)
Wind Loading 550 N @ 200 km/h
(123.6 lbf @ 125 mph)
Certications CE, FCC, IC
Operating Frequency (MHz)
Worldwide 5150 - 5875
US/CA U-NII-1 5150 - 5250
U-NII-2A 5250 - 5350
U-NII-2C 5470 - 5725
U-NII-3 5725 - 5850
Management Radio (MHz)
Worldwide 2412 - 2472
US/CA 2412 - 2462
Safety Notices
1. Read, follow, and keep these instructions.
2. Heed all warnings.
3. Only use attachments/accessories specied by the manufacturer.
WARNING: Do not use this product in location that can be submerged by
water.
WARNING: Avoid using this product during an electrical storm. There may be a
remote risk of electric shock from lightning.
LBE-5AC-LR Quick Start Guide
Electrical Safety Information
1. Compliance is required with respect to voltage, frequency, and current requirements
indicated on the manufacturer’s label. Connection to a dierent power source than
those specied may result in improper operation, damage to the equipment or pose
a re hazard if the limitations are not followed.
2. There are no operator serviceable parts inside this equipment. Service should be
provided only by a qualied service technician.
3. This equipment is provided with a detachable power cord which has an integral
safety ground wire intended for connection to a grounded safety outlet.
a. Do not substitute the power cord with one that is not the provided approved
type. Never use an adapter plug to connect to a 2-wire outlet as this will defeat
the continuity of the grounding wire.
b. The equipment requires the use of the ground wire as a part of the safety
certication, modication or misuse can provide a shock hazard that can result in
serious injury or death.
c. Contact a qualied electrician or the manufacturer if there are questions about
the installation prior to connecting the equipment.
d. Protective earthing is provided by Listed AC adapter. Building installation shall
provide appropriate short-circuit backup protection.
e. Protective bonding must be installed in accordance with local national wiring
rules and regulations.
Limited Warranty
ui.com/support/warranty
The limited warranty requires the use of arbitration to resolve disputes on an individual
basis, and, where applicable, specify arbitration instead of jury trials or class actions.
Compliance
FCC
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions.
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operations of this
LBE-5AC-LR Quick Start Guide
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
This radio transmitter has been approved by FCC.
ISED Canada
CAN ICES-3(A)/NMB-3(A)
This device complies with ISED Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
This radio transmitter has been approved by ISED Canada.
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems.
CAN ICES-3(A)/NMB-3(A)
Le présent appareil est conforme aux CNR d’ISDE Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. l’appareil ne doit pas produire de brouillage;
2. l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Le présent émetteur radio a été approuvé par ISDE Canada.
Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement
pour une utilisation à l’intérieur an de réduire les risques de brouillage préjudiciable
aux systèmes de satellites mobiles utilisant les mêmes canaux.
IMPORTANT NOTE
Radiation Exposure Statement
• This equipment complies with radiation exposure limits set forth for an uncontrolled
environment.
• This equipment should be installed and operated with minimum distance 103 cm
between the radiator and your body.
• This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
AVIS IMPORTANT
Déclaration sur l’exposition aux rayonnements
• Cet équipement est conforme aux limites prévues pour l’exposition aux
rayonnements dans un environnement non contrôlé.
LBE-5AC-LR Quick Start Guide
• Lors de l’installation et de la mise en fonctionnement de l’équipement, assurez-vous
qu’il y ait une distance minimale de 103 cm entre l’élément rayonnant et vous.
• Cet émetteur ne doit être installé à proximité d’aucune autre antenne ni d’aucun
autre émetteur, et ne doit être utilisé conjointement à aucun autre de ces appareils.
Australia and New Zealand
Warning: This equipment is compliant with Class A of CISPR 32. In a residential
environment this equipment may cause radio interference.
Brazil
Nota: Este equipamento não tem direito à proteção contra interferência
prejudicial e não pode causar interferência em sistemas devidamente
autorizados.
CE Marking
CE marking on this product represents the product is in compliance with all directives
that are applicable to it.
Country List
AT BE BG CY CZ DE DK EE EL ES FI FR HR HU
IE IT LV LT LU MT NL PL PT RO SE SI SK UK
BFWA (Broadband Fixed Wireless Access) members noted in blue
Note: This device meets Max. TX power limit per ETSI regulations.
The following apply to products that operate in the 5 GHz frequency range:
Note: This device is restricted to indoor use only when operating in the 5150 -
5350 MHz frequency range within all member states.
Note: All countries listed may operate at 30 dBm. BFWA member states may
operate at 36 dBm.
Note: Operation in the 5.8 GHz frequency band is prohibited in BFWA member
states. Other countries listed may use the 5.8 GHz frequency band.
WEEE Compliance Statement
LBE-5AC-LR Quick Start Guide
La page charge ...
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
Ubiquiti LiteBeam LBE-5AC-LR Guide de démarrage rapide
- Taper
- Guide de démarrage rapide
dans d''autres langues
Documents connexes
-
Ubiquiti Bullet AC-IP67 Guide de démarrage rapide
-
Ubiquiti Loco5AC Mode d'emploi
-
-
Ubiquiti NBE-5AC-Gen2 Guide de démarrage rapide
-
-
-
-
-
Ubiquiti ROCKETM2-US Mode d'emploi
-
Ubiquiti U Mode d'emploi