Coral L4S3RE Digital Media Receiver Manuel utilisateur

Taper
Manuel utilisateur
User Manual
Product Information
Safety and Compliance Information
Using Your Device Around Other Electronic Devices
The Device, uses, and can radiate radio frequency (RF) energy and, if not used in accordance with its
instructions, may cause interference to radio communications and electronic equipment. External RF
signals may affect improperly installed or inadequately shielded electronic operating systems,
entertainment systems, and personal medical devices.
While most modern electronic equipment is shielded from external RF signals, if in doubt, check with
the manufacturer. For personal medical devices (such as pacemakers and hearing aids), consult with
your physician or the manufacturer to determine if they are adequately shielded from external RF
signals.
There are some places where RF signals could constitute a hazard, such as health care facilities, and
construction sites. If you are not sure, look around for signs indicating that two-way radios or mobile
phones should be turned off.
FCC Compliance Information
Radio Frequency Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications that are not expressly approved by the party responsible for compliance could
make the device no longer comply with the FCC Rules.
Information on your device is on file with the FCC and can be found by inputting your device’s FCC ID,
which can be found on the back of Device, into the FCC ID Search form available at
transition.fcc.gov/oet/ea/fccid.
Information Regarding Exposure to Radio Frequency Energy
This equipment complies with RF exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20 cm between the radiator & your
body.
IC Compliance Information
Radio Frequency Information
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement."
The device could automatically discontinue transmission in case of absence of information to transmit,
or operational failure. Note that this is not intended to prohibit transmission of control or signaling
information or the use of repetitive codes where required by the technology.
This device for operation in the band 51505250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
Les dispositifs fonctionnant dans la bande de 5 150 à 5 250 MHz sont réservés uniquement pour une
utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites
mobiles utilisant les mêmes canaux.
Information Regarding Exposure to Radio Frequency Energy
This equipment complies with IC RSS-102 RF exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20 cm between the radiator &
your body.
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de
distance entre la source de rayonnement et votre corps.
CAN ICES-3(B)/NMB-3(B)
Recycling Product Properly
In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of or
recycle the Products in accordance with your local laws and regulations. For information about recycling
the Products, go to www.amazon.com/devicesupport.
Product Specifications
Model Number: L4S3RE
Power: 18VDC 1.67A output power adapter (in-box)
Operating temperature: 0°C to 35°C
Connectivity: Dual Band Wi-Fi (2.4/5 GHz), 802.11 a/b/g/n/ac; BT BDR/EDR, BLE, 902-928MHz
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Coral L4S3RE Digital Media Receiver Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues