Amazon P5N8EC Manuel utilisateur

Taper
Manuel utilisateur
User Manual
Product Information
Safety and Compliance Information
Using Your Device Around Other Electronic Devices
The Device, uses, and can radiate radio frequency (RF) energy and, if not used in accordance
with its instructions, may cause interference to radio communications and electronic
equipment. External RF signals may affect improperly installed or inadequately shielded
electronic operating systems, entertainment systems, and personal medical devices.
While most modern electronic equipment is shielded from external RF signals, if in doubt, check
with the manufacturer. For personal medical devices (such as pacemakers and hearing aids),
consult with your physician or the manufacturer to determine if they are adequately shielded
from external RF signals.
There are some places where RF signals could constitute a hazard, such as health care facilities,
and construction sites. If you are not sure, look around for signs indicating that two-way radios
or mobile phones should be turned off.
FCC Compliance Information
Radio Frequency Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications that are not expressly approved by the party responsible for
compliance could make the device no longer comply with the FCC Rules.
Information on your device is on file with the FCC and can be found by inputting your device’s
FCC ID, which can be found on the back of Device, into the FCC ID Search form available at
transition.fcc.gov/oet/ea/fccid.
IC Compliance Information
IC Compliance Information
Radio Frequency Information
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
The device could automatically discontinue transmission in case of absence of information to
transmit, or operational failure. Note that this is not intended to prohibit transmission of
control or signaling information or the use of repetitive codes where required by the
technology.
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems;
Les dispositifs fonctionnant dans la bande de 5150 à 5250 MHz sont réservés uniquement pour
une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes
de satellites mobiles utilisant les mêmes canaux.
CAN ICES-3(B)/NMB-3(B)
Product Specifications
Model Number: P5N8EC
Electrical Rating: 5V 3A
Connectivity: Bluetooth, Bluetooth Low Energy, Wifi 2.4 GHz and 5 GHz, NFC, GNSS RX, WPT RX
Temperature Rating: 0°C to 35°C
Operating temperature: 0°C to 35°C
How to use
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Amazon P5N8EC Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues