There are some places where RF signals could constitute a hazard, such as health care facilities, and
construction sites. If you are not sure, look around for signs indicating that two-way radios or mobile
phones should be turned off.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Product Specifications
Equipment Name: Tablet
Model: L5S83A
Ports: Micro-USB, Audio port
Power — DC 5.2V, 1.8A, or DC 5.25V, 1.0A or DC 5 V, 1A or DC 5V, 1.8 A output power adapter (sold in-box)
Operating Voltage – 3.4V to 4.2 VDC
Connectivity — Dual Band Wi-Fi (2.4 GHz&5 GHz); 802.11a/b/g/n; BT 3.0, BLE 4.2
Operating frequency — WLAN 2.4GHz: 2402 - 2480 MHz; WLAN 5GHz: 5150 – 5250 MHz; 5250~5350 MHz;
5470~5725MHz; 5725~5825MHz; Bluetooth 3.0 / 4.2: 2402 – 2480 MHz
Operating temperature — 0 °C to 35 °C
Remark: 5GHz band(W52,W53): Indoor use only
FCC Compliance Information Radio Frequency
Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.