Philips S1332/41 Une information important

S1000

2

1

7

8

3

4

5

10

9

6

empty page before TOC

English 6

Français (Canada) 22

English

Contents

Introduction_______________________________________________________ 6

General description (Fig. 1)_______________________________________ 6

Important safety information_____________________________________ 7

Charging___________________________________________________________ 9

Charging indications______________________________________________ 10

Using the appliance______________________________________________ 11

Shaving____________________________________________________________ 11

Trimming__________________________________________________________ 12

Cleaning and maintenance_______________________________________ 13

Replacement______________________________________________________ 16

Storage____________________________________________________________ 18

Ordering accessories_____________________________________________ 18

Recycling__________________________________________________________ 18

Removing the rechargeable shaver battery_____________________ 19

Warranty and support____________________________________________ 21

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benefit from the support that

Philips offers, register your product at

www.philips.com/welcome.

General description (Fig. 1)

1 Protective cap

2 Shaving unit

3 Shaving unit release button

4 On/off button

5 Charging light

6 Trimmer release slide switch

7 Pop-up trimmer

8 Socket for small plug

9 Supply unit

10 Small plug

6

English

Important safety information

Read this important information carefully before

you use the appliance and save it for future

reference.

Danger

- Keep the supply unit dry.

Warning

- To charge the battery, only use the detachable

supply unit (HQ8505) provided with the

appliance.

- The supply unit contains a transformer. Do not

cut off the supply unit to replace it with another

plug, as this causes a hazardous situation.

- This appliance can be used by children aged

from 8 years and above and persons with

reduced physical, sensory or mental capabilities

or lack of experience and knowledge if they

have been given supervision or instruction

concerning use of the appliance in a safe way

and understand the hazards involved. Children

shall not play with the appliance. Cleaning and

user maintenance shall not be made by

children without supervision.

- Always unplug the shaver before you clean it

under the tap.

- Always check the appliance before you use it.

Do not use the appliance if it is damaged, as

this may cause injury. Always replace a

damaged part with one of the original type.

- Do not open the appliance to replace the

rechargeable battery.

7

English

Caution

- This appliance contains batteries that are non-

replaceable.

- Never immerse the charging stand in water and

do not rinse it under the tap.

- Never immerse the shaver in water. Do not use

the shaver in the bath or in the shower.

- Never use water hotter than 60°C to rinse the

shaver.

- Only use this appliance for its intended purpose

as shown in the user manual.

- For hygienic reasons, the appliance should only

be used by one person.

- Never use compressed air, scouring pads,

abrasive cleaning agents or aggressive liquids

such as petrol or acetone to clean the

appliance.

- Water may drip from the socket at the bottom

of the shaver when you rinse it. This is normal

and not dangerous because all electronics are

enclosed in a sealed power unit inside the

shaver.

- Do not use the supply unit in or near wall

sockets that contain an electric air freshener to

prevent irreparable damage to the supply unit.

Electromagnetic fields (EMF)

This Philips appliance complies with all applicable

standards and regulations regarding exposure to

electromagnetic fields.

8

English

General

- This shaver can be safely cleaned under the

tap.

- The supply unit is suitable for mains voltages

ranging from 100 to 240 volts.

- The supply unit transforms 100-240 volts to a

safe low voltage of less than 24 volts.

Charging

Note: You can also use the shaver while it is

plugged-in and charging.

Charge the shaver before you use it for the first

time and when the display indicates that the

battery is almost empty.

When you charge the appliance for the first time or

after a long period of non-use, let it charge until

the charging light lights up continuously.

Charging takes approx. : 8 hours (S1232 only) or 1

hour (S1332 only). A fully charged shaver has a

shaving time of up to 40 minutes (S1232 only) or 45

minutes (S1332 only).

S1332 only

Note: Before first usage charge the appliance for 3

hours without interruption and until the battery

charging indication shows that the battery is full.

This is needed to make maximum use of the

battery capacity. All future charges will take 1 hour.

Charging with the supply unit

2

1

1 Put the small plug in the appliance.

2 Put the supply unit in the wall socket.

- The charging light shows the charging status of

the appliance.

9

English

3 After charging, remove the supply unit from the

wall socket and pull the small plug out of the

appliance.

Charging indications

Battery fully charged

When the battery is fully charged, the charging

light lights up white continuously.

Note: After approx. 30 minutes, the charging light

goes out to save energy.

Battery low

- When the battery is almost empty (when there

are only 5 or fewer shaving minutes left), the

charging light flashes orange.

- When you switch off the appliance, the charging

light continues to flash orange for a few

seconds.

Charging

When the shaver is charging, the charging light

flashes white.

Quick charge (S1332 only)

When you start charging the empty battery, the

charging light flashes white quickly. After approx. 5

minutes the charging light flashes white slowly. The

shaver now contains enough energy for a

5-minute shave.

10

English

Using the appliance

Note: This appliance can be used without cord or

when it is connected to the wall socket.

Shaving tips and tricks

- Make circular movements during use. Circular

movements provide better shaving results than

straight movements.

- Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

Switching the appliance on and off

1 To switch on the appliance, press the on/off

button once.

2 To switch off the appliance, press the on/off

button once.

Shaving

Dry shaving

Note: For the best results on skin comfort, pre-

trim your beard if you have not shaved for 3

days or longer.

1 Switch on the appliance.

11

English

2 Move the shaving heads over your skin in

circular movements to catch all hairs growing in

different directions.

3 Stretch your skin with your free hand so the

blades can lift and cut hair. Gently press the

shaver onto you skin so the floating heads can

follow the contours of your face.

Note: Do not press too hard as too much

pressure can cause shaving heads to pinch the

skin.

4 Switch off and clean the appliance after each

use.

5 Put the protective cap on the appliance to

protect the shaving heads during storage and

travel.

- For the best results on skin comfort, pre-trim

your beard if you have not shaved for 3 days or

longer.

Trimming

Trimming with pop-up trimmer

You can use the trimmer to groom your sideburns

and moustache.

1 Push the trimmer release slide downwards to

open the trimmer.

2 Switch on the appliance.

3 Hold the trimmer perpendicular to the skin and

move the appliance downwards while you exert

gentle pressure.

4 Switch off and clean the trimmer after each use.

12

English

5 Close the pop-up trimmer (‘click’).

Cleaning and maintenance

Cleaning the shaver

Clean the shaver after every shave for optimal

shaving performance.

Caution: While rinsing shaving heads, water may

drip out of the base of shaver. This is a normal

occurrence. Internal electric parts are in a

waterproof compartment so the shaver will be

protected against water damage.

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

2 Press the release button to open the shaving

unit.

3 Rinse the shaving unit and hair chamber with

lukewarm water.

4 Rinse the outside of the shaving unit with

lukewarm water.

13

English

Never dry the shaving unit with a towel or

tissue, as this may damage the shaving heads.

5 Carefully shake off excess water and let the

shaver air dry.

6 Close the shaving unit.

Cleaning the pop-up trimmer

Clean the pop-up trimmer after each use.

Never dry the trimmer teeth with a towel or

tissue, as this may damage the trimmer teeth.

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

2 Push the trimmer release slide button down to

open the pop-up trimmer.

3 Switch on the appliance and rinse the pop-up

trimmer with warm water.

4 After cleaning, switch off the appliance.

5 Carefully shake off excess water and let the

pop-up trimmer air dry.

6 Close the pop-up trimmer (‘click’).

Tip: For optimal performance, lubricate the teeth

of the pop-up trimmer with a drop of mineral oil

every six months (oil not included).

Thorough cleaning

Clean the shaving heads thoroughly once a month

for optimal performance.

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

14

English

2 Press the release button to open the shaving

unit. Pull the shaving unit off the appliance.

2

1

3 Turn the lock anticlockwise (1) and remove the

retaining frame (2).

4 Remove and clean one shaving head at a time.

Each shaving head consists of a cutter and a

guard.

Note: Do not clean more than one cutter and

guard at a time, since they are all matching sets.

If you accidentally mix up the cutters and

guards, it may take several weeks before

optimal shaving performance is restored.

5 Remove the cutter from the shaving guard and

clean both parts under the tap.

6 Put the cutter back into the guard.

15

English

7 Put the shaving heads back into the shaving

unit.

1

2

8 Put the retaining frame back into the shaving

unit (1) and turn the lock clockwise (2).

9 Insert the lug of the shaving unit into the slot in

the top of the appliance. Then close the shaving

unit ('click').

Note: If the shaving unit does not close

smoothly, check if you have inserted the

shaving heads properly and if the retaining

frame is locked.

Replacement

Replacing the shaving heads

For maximum shaving performance, we advise you

to replace the shaving heads every two years.

Replace damaged shaving heads immediately.

Always replace the shaving heads with original

Philips shaving heads (see 'Ordering accessories').

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

16

English

2 Press the shaving unit release button to open

the shaving unit. Pull the shaving unit off the

appliance.

2

1

3 Turn the lock anticlockwise (1) and remove the

retaining frame (2). Place it aside in a safe place.

4 Remove the shaving heads from the shaving

unit.

Discard the used shaving heads immediately to

avoid mixing them with the new shaving heads.

5 Place new shaving heads in the shaving unit.

Note: Make sure that the shaving heads with

the projections fit exactly onto the hooks of the

shaving head holder when placing them. The

shaving heads supplied with the shaver either

have notches or projections. Both shaving

systems are the same.

17

English

1

2

6 Put the retaining frame back into the shaving

unit (1) and turn the lock clockwise (2).

7 Insert the hinge of the shaving unit into the slot

in the top of the shaver. Then close the shaving

unit.

Note: If the shaving unit does not close

smoothly, check if you have inserted the

shaving heads properly and if the retaining

frame is locked.

Storage

Put the protective cap on the shaver to prevent

damage.

Note: Always let the shaver dry completely before

storing.

Ordering accessories

To buy accessories or spare parts, visit

www.philips.com/parts-and-accessories or go to

your Philips dealer. You can also contact the

Philips Consumer Care Center in your country (see

the international warranty leaflet for contact

details).

Recycling

- Do not throw away the product with the normal

household waste at the end of its life, but hand

it in at an official collection point for recycling.

By doing this, you help to preserve the

environment.

18

English

- This product contains a built-in rechargeable

battery which shall not be disposed of with

normal household waste. Please take your

product to an official collection point or a

Philips service center to have a professional

remove the rechargeable battery.

- Follow your country’s rules for the separate

collection of electrical and electronic products

and rechargeable batteries. Correct disposal

helps prevent negative consequences for the

environment and human health.

Removing the rechargeable shaver battery

Only remove the rechargeable batteries

when you discard the appliance. Before you

remove the batteries, make sure that the

appliance is disconnected from the wall

socket and that the batteries are

completely empty.

Take any necessary safety precautions

when you handle tools to open the

appliance and when you dispose of the

rechargeable battery.

Be careful, the battery strips are sharp.

1 Press the shaving unit release button to open

the shaving unit. Pull the shaving unit off the

shaver.

19

English

2 Remove the screw in the back of the shaver.

3 Remove the back panel by using a flathead

screwdriver.

2×

4 Remove two screws and then remove the hair

chamber from the shaver.

5 Lift out the front panel.

20

English

La page charge ...

Philips S1332/41 Une information important

Philips S1332/41 Une information important

dans d''autres langues

Documents connexes

Autres documents